Cannot connect to belkin N1 wireless router

WIRELESS SECURITY ISSUES

Step 1 : Connect Router - Computer ( Wired)

Step 2 : Open Router Setup by typing http://192.168.2.1 on the address bar of internet explorer

Step 3 : On the left under wireless click wi - fi protected setup

Step 4 : Leave the password blank and click on submit

Step 5 : Disable it and Click on apply changes

Step 6 : On the left under wireless click Security

Step 7 : Enable 64 Bit WEP

Step 8 : Type a 10 digit number on the key 1 ( 2 in each box )

Step 9 : Click apply changes

Step 10 : on the left under wireless click channel and SSID

Step 11 :Change the Wireless channel to 6

Step 12 : Change the SSID to a different name ( no Spaces )

Step 13 : Click apply changes

Step 14 : Now Scan and connect to this network ( Wireless )

Let me know if it works

Step 1: Connect Router - Computer (Wired)

Step 2:Open Router Setup by typing http://192.168.2.1 on the address bar of internet explorer (You can use any Web browser )

Step 3:On the left, under wireless click on channel and SSID (leave the password Blank and click submit )

Step 4: Change the Wireless Channel to 6 ( If its already 6 change it to 11)

Step 5: Click apply changes

Step 6: unplug the Router

Step 7: Restart the Computer

Step 8: Plug the power Cable back to the Belkin

Step 9: Connect to your wireless network

I have 2 x Belkin N1 vision dsl (cable) routers. One is connected fine with Virgin 20 meg broadband. Is it possible to use the other N1 vision router as a range extender up stairs to get better signal , without using any cat5 cabling ? I.e router-to-router

if you connect your xbox and it works than it is not your isp

go to your network setup and try it with fix ip and DNS to you vista laptop wirless card /fixed card ip setup

goodl luck get back if this does not work with more info on your network setup

I had this with Bt Internet and this exact same router, you have to phone Belkin up and they give you a complete set of new settings that you manually have to put in during setup. If i remember rightly its a free phone number and the operator who answered spoke semi-english so not all bad, hope this helps.

Chris E

1st You download Webcam Driver.
WVC54GCA camera - setup is ok with cable install but once going to wireless, no go using Belkin N1 router
After this install the Webcam driver in the system.
Installation of Webcam Driver
Go to the control panel
Click on the System Icon
Click on the Hardware Tab
Click on the Device Manager s
Select the Unknown Device or printer device where yellow Question Marks sign on it.
Right click on it and uninstall it.
After this go to the top of the device manager and click on scan for hardware changes.
Driver installation Wizard start.
Brows Your Driver from the Hard Disk and click on next.
Driver will be install.

Disable your Firewall/NAT service or open ports 25, 110 and 141

you can use as many as you want, since they just find a signal and amplify it. using more than one shouldnt cause any problems

to make sure its setup properly you should reset it up, to do this press the reset button on the back of router, and then when its up to a ready state acess it through your web browser. the adress is 192.168.2.1 ,then click the login button, the defualt password is blank. after that your are logged into the router you can run the setup wizard located on the left hand side of the page. once setup is complete you should be able to acess the internet.

on the 1st plase u should chek your encrpchen code