Serial Problem Xerox Docuprint 240A

Page 419 of the manual says to contact an authorized dealer after turning the unit off and then back on, if the error persists.
Xerox DocuPrint CM205 User Manual Understanding Printer Messages then refers you to page 465 "online services"

This is the error I get from GetLastError() after calling GetPrinter() to get the size needed to declare the PRINTER_INFO_2 structure:
An unexpected error occurred when executing the test.
Error Code = 124.
Error Message = The system call level is not correct.

for more help visit CBR Tech Solutions

I have Fuji xerox docuprint 340a.
but It doesn't work with a error.
The error is 006-335(reboot the printer)
I did what printer said, It goes again.
What can I do for this printer?

How to reboot printer Xerox DocuPrint C4350 error code : printer (124-315)

Hi there!
The message 009-NNN is the REQUEST PARTS message. Depend on your number(in this case 363), the part of your printer need to replace.
Try to turn off, wait atlease 15 seconds and turn on your printer again to see the message clear or not. If not, you have to call Xerox Customer Support for replacement.
Under is original text from Xerox DocuPrint C2535A User Guide.
---------------------------------

Please Request

Parts 009-NNN

Switch the printer off and then on. If the error is not cleared, the developer unit needs

to be replaced. Contact our Customer Support Center or your dealers for assistance.
-------------------------------------------------
Hope this will help. Thanks for reading

Drivers and support information can be found here.

http://onlinesupport.fujixerox.com/setupDriverForm.do?ctry_code=AU&lang_code=en&d_lang=en&pid=DPC1190FS


How To Find the Serial Number

The Serial Number is located on the back of the machine.

Alternatively the Serial Number can be found in CentreWare Internet Service. This screen displays the printers product name and serial number.

Trust this is helpful. Please vote. :)

How to reboot printer Xerox DocuPrint C4350 error code : 009-383

You need to switch off the printer and then connect it via the USB cable. Press the hold and cancel buttons simultaneously. Then power on the printer again. On your LCD display you should typically see a message saying 'ready for download mode'. You will then need to initialize the firmware update process. LCD will change to the writing mode. 10 minutes later you will be prompted to start the printer again.
Keep me posted abt the end result...

This printer have a sensor to remind the user when using a wrong paper size.

If you still using a paper that not the same with your software settings, it's still reminds you.

I solve this promblem by after print my works I just press "Cancel Jobs" button to clear a data.

Good luck.

001-360 Fan motor failure Check Fan Rear Check Fuser Fan Check voltage on fan rear should be between 15VDC and 24VDC. Check voltage on fuser fan should be 24VDC