- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
When the trigger is pressed, the engine should kick up to increase speed and thus pressure. There is a problem with either gas flow or the air is blocked (new air filter?), so I would start by cleaning the carb and make sure the small gas port is open (run a pipe cleaner through it).
Open the drill carefully plug in mains chech with multimeter that mains is available at cord in connections if not this means cable break if yes check trigger out power is ok by pressing trigger if power is ok check output ca
ble to main are connected ok if all ok then the stator might be damaged hope this helps
Hi Cliff:
My experience is that the pump pressures prevent the engine from starting, so we hold the trigger while starting.
My brother has cut a wedge of wood that he uses to jam the trigger open to bypass the problem. It can get a bit wild if the wand is not secured when the unit is started..
It isnt very clear your explanation of the problem but what type washer do you have first? It sounds like you have a bad unloader or need a new variable nozzle tip. Can you explain in more clear detail. Thanks
Sound like you have a machine programed on stitch mode, to override the program do the following:
1)Turn off the machine
2) With the machine turned off press the gun trigger.
3) Turn on your machine keep the trigger pressed, hold it for about 3-5 seconds. Depress the trigger and you should be good.
1. Shut the power off, and disconnect your Ryobi router. It could be the start/stop switch. So, you can begin checking the switch contacts using the multi-tester. Set if at 1 x 10 Ohms. Put the probes of the tester across the switch terminals. Pressing the trigger on will move the tester indicator to zero if your switch is okey. Otherwise, no moverment - the trigger switch need replacement. 2. Should the trigger switch proved to be okey, Check the carbon brush of the unit, short carbon brush?? you have to replace it.
×