SOURCE: AEG 40850 not filling after leak
check pcb board sounds like its blown something
Testimonial: "Hi Martyn, thanks for the post. Any idea where the pcb is on the 40850, its not obvious, only pumps and pipes in the bottom tray and some small potted components."
The E20 error code indicates a problem with water drainage. Inspect the drainage hose for kinks that could impede the drainage flow. This frequently occurs when the machine is pushed up against the wall without allowing room for the hoses. If there are no kinks, the hose is probably clogged. Carefully detach the hose from the machine, and use a garden hose to force water through it. If the water doesn't pass through, use a plumber's snake to clear the clog. If there is no clog, inspect the drain pump for clogs. Unplug the machine, and open the small rectangular door towards the bottom of the front of the machine. Drain the pump through the emptying hose into a container until the water flow stops, and rotate the pump impeller to clear any foreign objects. Close the pump and restart the cycle. If the problem persists, contact a service center.
94 views
Usually answered in minutes!
×