PRNDL fuse keeps blowing and i dont know why
Check wiring insulation or disconnect prndl and see if it clears
SOURCE: keep blowing fuses under hood.
REMOVE THE FUSES ONE AT A TIME FOR EACH ITEM ON THE 50 AMP CIRCUIT. I WOULD START WITH THE POWER WINDOW FUSE FIRST. IT WOULD BE THE MOST LIKELY SOURCE OF A HIGH VOLTAGE DRAW. THEN GO ON TO THE WIPERS AND SO FORTH.
SOURCE: THE IGN A FUSE UNDER THE HOOD KEEPS POPPING
You have a serious short. The fuse is keeping you from frying the electrical system. Did you make any changes to the vehicle recently? Is it all stock electrical? If so, check the Ignition relay in the alternate fuse panel. If that does not work, post a reply and I'll help you dig further. Hope this helps
SOURCE: need wiring diagram for 1995 chevy 1500 silverado 305.
need a wiring schematic for a 90 s-10 blazer cut the wires to dist now cant find leads
SOURCE: fuse for power doorlock keep blowing when i push lock but not when i push unlock
You have a ground either in the switch or in the wire going to the lock solenoid.
when you push the button to unlock power goes thru the wire and the solenoid
then to ground on the other wire that is grounded. when you push the button to
unlock, power is reversed, and goes to the grounded wire then poof-- the fuse
blows.
1,355 views
Usually answered in minutes!
×