My Canon A630 say "Busy"

Question edited to add full make and model.
Question moved from Dishwashers to Canon PowerShot A630.

https://www.google.com/search?q=take+the+back+off+the+screen+of+A630+camera

Personally, I would send it to Canon for professional service. It may just be a problem with insufficient battery milliamps.

https://www.google.com/search?q=A630+camera+E24+Error+Code

..

at the back of the camera there is a Display button (mark as DISP)
press it a few times until all symbols will dissapear on the screen

good luck

image from: http://www.cameras.co.uk/camera-reviews/canon-powershot-a630.cfm

Give the camera some time. Don't remove the battery till the reset is done. I hope your battery was charged before you started the reset.
If the battery runs out of power, you must charge it comlpete, before putting it in again. I hope the reset went well. If not only try a reset with a fully charged battery.

Hello. If the flash button was pressed, you must disarm the upper case and unlock thebutton. Good luck!

try using night mode indoors. otherwise, simply get into setup and go back to factory settings, and use AUTO mode. hope it helps

Try resetting the camera. Go into the setup menu and find "reset".

Turns out my husband must have pressed a button by accident. The bottom left button says "disp" for display. Pressing that fixed the screen!

Hi there and welcome to FixYa.

To reset your camera do this:
Press the menu button.
Scroll Right to the setup menu.
Scroll down to Reset All
Select OK and press the Func/Sel button.

Hope that helps. If you need the manual, you can find it here
http://gdlp01.c-wss.com/gds/0900001226/PSA640_630CUGad-EN.pdf

Rob

Try resetting the camera to factory defaults - Here's how:

• Firstly press the 'menu' button, then the up button above the 'OK' as many times as needed, until you see the top folders are highlighted.
  
  
• Press the right button near the 'OK' until you see the last folder highlighted. You will know this is highlighted when you see the first menu option that says 'Language'. The 3rd one down from that says 'Clear Settings'.
  
  
• Press the down button under the 'OK' until 'Clear Settings' is highlighted, then press the 'OK' button.
  
  
• Scroll up to your choice and press 'OK' to reset your Canon 400D back to default factory settings.

Hope this helps

first did you google : powershot a630 and drivers ??
second if none pops up, go to www.canon.com than select usa (with other canon site's you have to pay for drivers , select digital cameras, scroll to a630 (if listed) , select your operating system, download, install and enjoy.

if this is to much work , a cartreader may do the trick to upload your images on your pc