Cascio Twincept alarm and hourly signal issue

It's possible that some part in your watch hasn't been put back (properly) during the replacement procedure of the battery. I'd advise you to go back to the service point and let them check if all the internal part are complete (and in their right position)

This looks like a very old Cascio watch. If you REALLY want it to work be prepared for expensive troubleshooting by the Cascio shop.

DXB - Dubai
KBL - KabulKHI - KarachiDEL - DelhiDAC - DhakaRGN - Yangoon/RangoonBKK - BangkokHGK - Hong KongTYO - TokyoADL - AdelaideSYD - SydneyNOU - NoumeaWLG - WellingtonHNL - HonoluluANC - AnchorageLAX - Las Angeles (Airport)DEN - DenverCHI - ChicagoNYC - New York CityCCS - CaracasRIO - Rio de JaneiroLON - LondonPAR - ParisCAI - CairoJRS - JerusalemJED - JeddahTHR - Tehran

http://cyecorp.ro/dailylog/2012/01/07/cities-world-time-on-watches/

browse through my tips and you will find link for all Casio watch manual downloads.

Hello I was in the same problem the last 5 hours causea icant find my owner manual, i put a new battery on my "oldie" but great watch and pusshin and seting i got it....

You have to put in "alarm mode", remember you have to push BOTON MODE. Then you will be at "stand by mode", "data bank(phone) mode", "world time mode", "alarm mode" "chrono mode", and set (analog watch) mode"

then you are in "alarm mode" then push "REV and FWD BOTONS" at the same time, one time, or two times or three times, until the "beep icon and bell icon" are in ON mode

Good look

sareg@hot....

http://world.casio.com/wat/download/en/manual/


Use the four numbers on the back of your watch and you will have a PDF version of your instruction manual.

Hope this tip helps
R/
David

You can try turning the back around 180 derees or you may have lost the little spring inside of the movement when you replaced the battery.

Do not lay the tweezers across any contacts as you may damage the watch.
First you need to examine your watch movement and find an AC point (contact). Use an eyeglass, as the writings can be very tiny.
When found, touch an AC point with one arm of tweezers and battery+ with another arm simultaneously.
Some watches needs to do that twice, so, to be sure, do that twice.
If you are not comfortable with tweezers, you can use a thin wire, connecting one end of the wire to AC point and another to battery+.
Each shortcut should last for 3 seconds.

Do not forget to rate, please.

On most casio watch you can see AC (all clear) point , youy need to resset clock connecting this point with + on battery about 5 sec.

I have same problem but on my watch I do not see AC point. :)

regards
ststefan

push the mode button until you see h-s (hands set)
use the buttons at the right side to adjust when you are in that mode.