I have a toro timecutter z4200. While cutting the blades stopped cutting. When I pushed the pto back to off then pulled to reengage it pulled out and was melted. Went out and bought a new one and did the same thing after a few minutes. Fuses was burnt but not blown. Like they got really hot. I replaced them to. Can someone help me please it would b greatly appreciated.

SOURCE: motor stops when the pto or cutting blades are turned on or engaged.

you most likely have a bad safety switch. there is one under your seat,one on engagement lever for blades,and probably one or two more in other places.start with the one under your seat by unplugging it and then going ahead with normale start up and implement engagement. you will have found the bad switch when everything works as it should.replace switch if you feel its necessary or just leave unplugged. it will not affect performance or longevity of the tractor

SOURCE: bought a 2002 toro timecutter 18-52 zero turn lawn

Hello:

>>You can View a Breakdown/IPL of the Mower at this Site Addy, https://lookup3.toro.com/partdex/default.cfm and Select Start Parts Viewer. Now Enter the Model Numbers () and Click Search. Now Select View Assembly Drawings for your Year Model.
At the Bottom of the Page (#6), Use this Link to Locate your Local Toro Dealer who can Order the Manual for you or you can Contact Toro Using the Options at this Site Addy; http://www.toro.com/contact/Homeowner.html .
Please, Do Not Hesitate, If you Hit a Snag or this Does Not Correct the Problem, I am Here if You Require More Assistance.
Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Be Happy. Thanks.

Good Luck

Respectfully

jbridger (John)

SOURCE: Ford 601 cuts out few minutes after start up

Hi..my name is Keith..and i restore 9N's,2N's and 8N's...but the systems are basically the same...so..you know and i know its either ignition or fuel..on the ignition side..i would suspect either the condensor or coil is breaking down when the engine gets hot...and on the fuel side..if you have already cleaned the carb..i would suspect trash in the fuel tank or trash in your sediment bowl and valve..which can be cleaned or replaced..i hope this will help..its the simplest thing to check or replace..if it didnt help..please write back

SOURCE: Husqvarna yth2448 pto switch kills motor/battery will not charge

you may hav a bad alt. problem with the mower dying when you engage the pto is most likley a bad sensor or wire unplugged on the seat sensor.the way it works is if the blades are turning and it dosent sense you being on the seat the mower shuts down.this has been standard on mowers for quite a few years now. it keeps the blades from cutting you up if you fall off the seat while mowing. as for charging i would try cleaning the battery connections and get the battery checked first.

SOURCE: I have a scotts (made

sounds like safety switch