New JVC flat screen cuts off 10 sec. after cutting on

If you go jvc .com enter your model # ,there is an article on how to reset the tv. First you have to unplug your tv for 10 secs., plug it back in and press and hold the menu and vol- buttons while holding these buttons in press the power button once, count to 3 and release the menu and vol- button. The lillte blue light should be on. wait for 40 secs. the picture should now come back on. This worked for me, I had the same trouble

Bad news; the cost of the panel and labor will be close or equal to replacement cost for the whole set.
If you are lucky, you might find a used 'pull' at the site below:
Jimmy's Parts
Asian labor has made nearly everything 'disposable.'

The amber means there is a problem in the power supply, check shopjimmy.com or discount-merchants.com to see how much your ps cost to replace

Inverter board is attached to the screen panel on the left or right. the way you reconize it is by locating several connectors coming from the screen into that board. The inverter board sends power to the screen lamps so when you turn your tv on its bright enough to see the picture

U have a reminder.It show up because u press MENU button to show up.Press menu agian well disappear.

If you go jvc .com enter your model # ,there is an article on how to reset the tv. First you have to unplug your tv for 10 secs., plug it back in and press and hold the menu and vol- buttons while holding these buttons in press the power button once, count to 3 and release the menu and vol- button. The lillte blue light should be on. wait for 40 secs. the picture should now come back on. This worked for me, I had the same trouble.
mike

You could have a bad power supply in this puppy, if your repaced that you will be back in biz.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

do auto tunning,press menu & select tunning proses

utencilio posted this fix. It worked for my JVC LT-42X579.

Okay, I found a fix! Called JVC, spoke to somebody there, here it is:
1)unplug the TV completely, no wall no power strips, completely
2)wait 10 sec
3)plug TV back in and Turn it on, the light will still be doing the same thing
4)wait 30 sec
5)ON THE TV, not the remote, locate the menu, volume (-) and power button.
6)while simultaneously holding down the menu and volume (-) button, pressed the power button ONCE and continue to hold the other 2 for 10 sec.
7)on the remote control, go to menu>settings>system info
*** now this I know as a FACT will work on systems that display: JVC - ver.5.32FO001, but I don't know of any other versions***
8)press the mute button on the remote twice
9)unplugg TV again and wait 10 sec.
10) plug TV in and turn on

It SHOULD be working normally now... Thanx to the guys a JVC support for this one, I know it seems like an obvious first place to look, but sometimes it isn't. I for one checked online forums first

Here is the link for the manual:

http://resources.jvc.com/Resources/00/01/13/YA589ien.pdf




Don't forget to rate!!!