Error code e1 - Hoshizaki Freezers

The error code -H9 on a Frigidaire upright freezer typically indicates a communication error between the control board and the display board. To troubleshoot this issue, try unplugging the freezer for a few minutes, then plugging it back in to see if the error code clears. If the error persists, it may be necessary to replace one or both of the boards. Contact a qualified appliance repair technician for further assistance.

Read guides from this website:
https://finderrorcode.com/electrolux-refrigerator-error-codes.html

Error Codes Messages Blinking

Manual Samsung Refrigerator JDB3000AWS2

Without manufactur and model no answer

Error code 5 E : Ice Maker Function Error - Ice-ejector and level failed three times or more. May simply be a trapped piece of ice which is not too rare a problem especially if the freezer door is left open too long.The ice pieces will stick to each other. It may dislodge itself or if the problem persists you may have to de-freeze it ( letting the freezer defrost over night.)

Good Afternoon Glenda, thank you for your inquiry!

Is it possible that the error code is missing characters? According to my research 8 is not a valid error code. The number 8 is more like a temperature setting, however to be certain, let's try resetting the appliance. It is important to wait roughly ten minutes and then turn the unit on. Set the correct temperature and please allow 24 hours for the temperature to stabilize. The error code should clear and the unit resume to normal operations. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully.

Best regards!

I think that code is a mechanical error code. Not sure. Call the mfr and see what they say. You can google the code and model number and perhaps get it there.

Follow through with google punch in code and model.

E1 is usually pc bord failure I beleive

E1 - Control board problem

Notes: C, E

C:
Disables clean mode in Thermador device, allows cook and microwave

E:
1. Turn the clock selector knob to OFF
2. "Tweak" the oven control by turning the clock selector knob slightly to the left
(counter clockwise).
This may stop the flashing message/beeping and clear the display window.


Hope helps.