The appropriate color cannot be restored and the light continuously blinks on my sony wega KV-36FS12The appropriate color cannot be restored and the light continuously blinks on my sony wega KV-36FS12
You can't post conmments that contain an email address.
In CRT board isolate RGB input. Check plain retrace lines appears in white colour. Then jungle ic failure. Otherwise problem in crt board. Maybe dry soldered.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
How many times do this standby light blinks at a time of switch on? These blinks are fault indications. From the number of these blinks, you can get an idea about the faulty circuit section inside it. Count it. If you wish to get more details about the blinking codes to Sony TVs, check this link.
Depending on your TV, you may have a Color Temperature (Color Temp) and/or Hue setting in the menu. Use these options to adjust the picture to the setting that best suits your viewing preference. If your TV has a Color Temp setting, you will normally have the following options to select from:
Cool: Gives the picture a cooler, slightly bluish appearance.
Neutral: Gives the picture a neutral, more natural look and appearance.
Warm: Gives the picture a warmer, slightly reddish appearance.
If your TV has a Hue setting, follow the appropriate step below to make adjustments:
Move the setting to the right to reduce the reddish appearance.
Move the setting to the left to reduce the greenish appearance.
Dont use a damp cloth. Use an air hose or can air if possible. The color differences may be your color wheel and not your air filter. You may have to reset the projector to clear the alerts, just hold both volume buttons for 5 seconds. I've found its usually 30 seconds Hope it helps, good luck
A reset won't fix this. The standby light should be blinking a repeated count with a 3 second pause inbetween. Post that count here. That will indicate the circuit/condition that is preventing the set from turning on.
its not the time for new tv yet.as the problem you r facing is not a major problem.
Check for multiple poor solder connection on the sweep/power supply board.
or. just need to balance the three colors red,green and blue that may help. remove the front covers and look for black module that have screw and focus controls just move little bit left or rightbe carefull because you can loos the picture
FIVE Blinks---AKB circuit (AKB), the timer/standby indicator blinks for about
30 seconds then goes to the self-diagnosis function. Something is wrong with
the video. Check video out, Q705, 732, 761 and other components on the C
board, also check Q218, 219, 220 on the A board. Also unit be in IK blanking,
try turning up screen slightly.
The appropriate color cannot be restored and the light continuously blinks on my sony wega KV-36FS12
×