The LaserJet 2600n printer is connected to a network and had been performing just fine for the last two years. Suddenly it stopped printing the other day. After I power cycled the printer, it prints one document and it quits priting again. It will print one document after I power cycle the printer and then quits. The panel says "Ready". I can ping the printer just fine. Any ideas??
Blue stars, be careful to monitor that often. it seems lately that anti virus and firewall updates can tinker with those IP addy's. Took me several hours to figure it out!!
Sounds like low toner to me. If the printer is connected by USB or parallel cable to one computer, go to that one. Click start-programs-HewlettPackard-HPlaserjet utility. The utility should let you see how much of each toner color remains.
293 views
Usually answered in minutes!
Toner was fine. There was a IP conflict with the printer, I'm not sure what though.
Changing the IP address of the printer fixed the problem.
Our HP Color Laserjet 2600n printer quit printing. I can print the demo/conf page from the printer but cannot print a test page. I have tried everything from the manual but to no avail. It had printed a page and then it quit. Any suggestions to what I can check out. This is a shared printer and is connected via UBS cable. I have checked the cable and disconnected & reconnected. Also turned the printer on/off. I am at a lost.
Nice, That was right on. I added the 2600N to a server, and ever since, had to restart the print spooler after every print job. I went to the printer panel and entered a new ip address and everyone can print just fine now. Our servers give out DHCP addresses from 192.168.10.128 thru 254. So I just gave it an IP address lower than that. 192.168.10.27. No reconfiguring, or anything! Thanks!!!
×