Problem with Element Electronics FLX2211B 22 in. LCD TV. Program blocked message pops up on screen for 3 to 5 seconds while watching TV. How can I stop this from happening?

Try to change the setting of your picture size in the AV format.

Ur tv have a dead board that call the LCD inverter board.This LCD inverter board it is a Long board.It only job are to provided a backlight to the tv LCD screen panel to produced a picture.Tries websites like Shopjimmy.com,Ebay.com to buy a long refurbish LCD inverter board for the replacement.

The electroliytic caps on the power supply module needs change, or ust replace the power supply.

Any computer cord will fit this model tv.

Element TV ELEFT422 can be controlled by Sony BluRay Player remote model # RMT-B118A by entering the code 04 (same as Goldstar and LG TVs)

Reset your TV to default settings through the menu, go from there.

this a defective board, psu or inverter board, need to be checked. send to electronics repair store.

has problem on the board.the solder is loose or loose solder

unplug the set from the surge protector and leave unplugged for over an hour then it should work just fine

I have run into the same problem with a different model (32 inch from Circuit City). You may have found that there is almost no support from the co or web. I do not have an official solution but have some work arounds that have done the job for me.
WA#1 = after a channel scan tune to a HD/digital channel before you turn the set off. You need to do this each time for several times, because the set when turned on to a regular cable or analog station will default to skip all channels. After several times the set should remember your channels.
WA#2 = after a channel scan, go to the skip channel section of the menu, and if your remote has the colored buttons on the bottom scroll through the channels using the red and green (up and down on this menu) buttons. This apparently helps the set remember not to skip your scanned channels.
These are not glamorous solutions but appear to trick the TV into not re-setting the skip function for the channels.
Best of luck.