WE HAVE RCA EXECUTIVE SERIES PHONES INTERCOM LIGHT FLASING

hang up all lines maybe you should charge it

you can contact the mobile service provider.....

I have an RCA Executive Line 4-line phone. I was away for a week, and came back to find the speakerphone when I dial out is significantly muffled on some of the lines (people that I am calling complain of noise on the line). If I take it off speaker, the quality on the handpiece is normal. First, I thought it was the batteries, so I replaced them. Didn't change. Is there a reset? Is the phone (base) after less than 1 year defective?

how do I forward/unforward phones remotely?

such B.S. all I needed was how to use my intercom feature and you want to charge me 50 bucks, man that is some kind of **** you have going on there, you should change the site name from FIXYA TO FUKYA

No ringer could well be a setting and light on 2nd line means their is No 2nd line and most 2 to 4 lines phones at least require 2 active lines for the system to work correctly

You can download the manual at the following link:

http://support.rca.com/doc/Device_Documents/manuals/25404RE3_manual.pdf?deviceDocId=15&navtypeid=6&pagetypeid=2&prevPageIndex=6&selectedmodel=25404RE3&selectedFamily=generic&nvty=m

Hope this helps. Please rate my advice, too.

Good luck!

I put it on hold, then use the intercom to notify another station to pick it up.

If you are looking for a message on hold port, you will not find one. Technically speaking, this is not a phone "system." There are 2 options for using messages on hold with your phones:
1) Using a message on hold player with a built-in adapter
2) Using a message on hold player and a separate adapter

The best option can be a little tricky to determine. We work with hundreds of small businesses that have 2,3,4 line phones and can help you figure this out and deliver the best solution. Please call me.

800-832-4653 ext.240 (Drew, Sales Mgr, Commercials On Hold)

Each of the six phones must have line 1 connected to the same "subscriber loop" (the same phone number). Assuming this is the case, and that you have not assigned any numbers to the the top six speed-dial buttons, each station will have agreed to be assigned a station number.

From any station, pressing the speed-dial button for another station's station number will page that station.

Now, how to properly initiate an intercom conversation differs between announcing to another station that a call is on hold, or a "cold call".