System error zoom - Panasonic Lumix DMCF2 Digital Camera

See if a software update available on the manufacturers website

Try these procedures.

You can't. it is cause by something blocking the gears or the lens being knocked to the side. Here is the online service form


http://www2.panasonic.com/webapp/wcs/stores/servlet/RequestCenter?storeId=15001&catalogId=11017

gerrting a message system erroe (zoom)

Lens errors (system error zoom on Panasonics) are fairly common. Usually it's sand or grit interfering with the lens extension mechanism. Or the camera's been dropped with the lens extended. Or the camera has been powered on, but the lens had been blocked preventing its extension. Or the battery ran down with the lens extended ...Here are some troubleshooting steps that you can try that may (or may not) correct it. They only seem to work for less than 40% of the lens errors, but if the camera is out of warranty (or repair cost approaches that of the camera), they're worth that try. Some of the later steps do involve some risk to the camera, so carefully weigh your options before deciding to conduct them:

HI there the camera lens guide pin is damages and thats why not zoom the image properly . You got the system error message. So you need to replaced or repair the lens guide pin. Thanks.

might need formatted
could try calling the maufactoring company where you got it.

there is a small gear on inside zoom lense that one not working chaing that part

try formatting the cam

At the start of a device BenQ DC E610, after the release of the target, the message "System Error 0010" will appear and the digital zoom will retract