Steam not frothing properly (very weak output)

Possibly an electronic problem. My did something similar. Need tech to replace appropriat part then sell it and get a msnusl machine.

Same problem here as well. The machine is only a few weeks old. Waiting for a solution :(

Probably the steam outlet tube from the boiler is blocked with the calcium bits which doesn't dissolved completely. Put descaling solution in water tank and do hot water and steam alternatively.(hot descaling).Make sure you put a jug of water to catch the steam( gas) in the steam wand After doing for about 5 mins, do the normal descaling and rinsing. Hope it helps. If not.......you may have to open the machine and removed the blockage physically.

If you model has dual boilers then the steam boiler is damaged, if it only has a single boiler, then either the thermostat on the boiler or the cpu board the tell is to pulse steam is damaged.

run hot water from the steam nozzle for few seconds

Hi
!/4 turn is all the Magic and Royal machines will do. Don't try to turn it farther or you could break the steam valve.

alisha165,

the saeco royal digital dosn't froth milk.... it produces steam, you are the one that froths the milk. is the machine still producing steam? if not you will need to have your steam boiler replaced. This should only be dune by a qualified repairer. If it is still producing steam but it is not as good as it use to be, descalling you machine may help.

Hi,

I think you have a tube in the machine from the rapid steam boiler that is blocked.

Best regards
/Mirran

Hi,

I think you have a pipe leakage.

Take of the top and see how it look inside, if you have a leak then it will go down to the power button and you will have a short circuit.

Hi,

There can be some calcium in your rapid steam boiler, try to descale the machine and see if it help.