Hi. My Aquasmart WL80T65CW1 is now displaying the error/fault code 250. Could you please tell me what this means and how I can fix this problem? Thanks, much appreciated.
250. (11111010) SmartPump Loss Of Sync
This fault is normally as a result of the pump not starting. This fault is usually caused by an
object that has gotten into the pump, and is either under or on top of the impeller, which is
causing the motor to stall when it is trying to start.
Primary Source: Pump Stator Windings Open Circuit.
Action: Measure the resistances of the pump stator. For more information
refer to the AquaSmart service manual.
Secondary Source: Pump System.
Action: Follow procedures as for Fault Code 249.
Tertiary Source: Motor Control Module.
Action: Replace Motor Control Module.
SOURCE: my aquasmart fisher and paykel
Sounds like the 'lid lock' has shorted out. They're not completely waterproof and have seen pins completely blown out inside them. Should measure 73 ohms (or very close to it) across the terminals. Hope this helps.
SOURCE: error code 49 on fisher and paykel 8kg aqua smart
Hi just read your posting.Error code 49 means the computer has measured a voltage from the valve diagnostic circuit that indicates the cold valve is faulty.Would you like help in confirming that the cold valve is faulty?You need an electrical test meter.Please reply and I can guide you thru the testing procedure.Looking forward to your reply.
SOURCE: Replace LCD display and machine control for Fisher
Thanks for choosing FixYa and welcome to the site. Are you sure it is 24? Below is a link to the manual. The error codes are about 1/3 of the way down.
http://www.scribd.com/doc/48997386/Fisher-and-Paykel-SmartDrive-Service-manual-053-MW053-u-2010-05-31-170211-GWL-11US-FandP-service-manual
513 views
Usually answered in minutes!
×