Wont go into final spin

Hi


Thanks for using FixYa. ULis displayed when the machine/motor control detects an off-balance load, and is steady on while the washer runs a mini-cycle to rebalance the load.
• Display clears if mini-cycle successfully rebalanced the load.
• If the mini-cycle is unsuccessful, uL will flash until the door lid is opened, allowing the customer to view and redistribute the load. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

It be the carbon brushes are worn down on the motor, when it goes into the final spin.

Check the drain line for kinks or obstructions and check the pump. It isn't just whether the water drained, but how quickly it drained as well. Remove the hoses from the pump and use a flashlight to look into the suction port. Make sure that nothing is clogging the pump like that occasional stray sock, etc., and check the pump impeller. Make sure there are no broken or missing blades and that the impeller spins freely. If there are any broken/missing blades or if you cannot get the impeller to spin freely, the pump is defective. Hopefully it's just a clogged drain line, pump, or jammed impeller. Sorry for your trouble and I hope this helped. Best wishes.

most likely a code is stored in the computer as it probably encountered an error getting up to speed. this would probably be in the motor control board on bottom not the main control on top. main control will have the error though. tech sheet should be located in base of machine on side wall remove rear panel and look to left. this will tell how to access diagnostic mode and retrieve code.

You have a motor coupling gone.

The first thing to check is if the door is locking. Put the unit into spin turn unit on let it go for about a minute then shut it off, try to open the door right after you shut it off if the door opens you need a door switch if not chances are you need a motor control board. Before replacing the board call for service they are expensive if it is a guess. good luck

http://www.instructables.com/id/GE-Adora-Lint-Filter-Cleanout/?download=pdf

Do this - I had the same problem and this fixed it. It takes about 10 minutes.

Machine has a bad motor or "stator" on this machine. It is a direct drive winding on the back of the machine. Remove the back panel, the one bolt removes the rotor then you will see the stator winding, replace it and your good to go.

"LE" error means the motor has overloaded. There is no way to fix this yourself. You will probably need a new motor. Call for an engineer.

My problem is that water is still draining when it goes to final spin. final spin is not working properly. then machine shuts itself off before timer.