N ricoh 2015 printer i want print the username in each paper while printing

Login Issue Assistance


User
Ricoh aficio mp 2000 can't print asking for log in username and password?
I never set any log in details, I have tried Admin,Supervisor with a blank password but not working, please assist

ChatGPT
If you're being prompted for a login username and password on your Ricoh Aficio MP 2000 printer and you haven't set any login details before, there are a few things you can try:

Default Login Credentials: The default username and password for Ricoh printers are often set to "admin" for both the username and password. Try using "admin" as both the username and password to see if it works.

Factory Reset: If the default login credentials don't work, you can try performing a factory reset on your printer. This will reset all settings, including any login information that might have been set. However, keep in mind that a factory reset will also erase any other custom settings you have configured on the printer. To perform a factory reset, you can refer to the printer's user manual or contact Ricoh support for specific instructions.

Contact Ricoh Support

1. The cover is open.
• Close the cover.
2. No paper in the tray
• Load paper in the tray.
3. The printer has stopped printing due to a major error.

4. The print cartridge is not installed.
• Install the print cartridge.
5. The life of the print cartridge.
• Replace the print cartridge

Hello probsy,
I know what your problem is. But it's a matter of me properly conveying the information. Bottom line is that you you either have a corrupt print driver or the wrong print driver. A print driver is the program that is loaded on your computer (or your server if you have one) that enables your computer to communicate with/and submit data TO the printer. If the "driver" is corrupt or wrong, then the printer "MAY" still understand that it needs to print something.......but then you get the **** you are talking about. I have seen printers absolutley run the paper out of every tray printing squiggles and numbers and then ask for more paper !! So for example you have a Ricoh printer but you are using the print driver for a Xerox printer. The printer MAY recognize the command to "PRINT", but what it prints will be.....who knows? At this point I have answered your question. I would go further but you will need to remove the printer from your pc and reload and install the CORRECT/CLEAN driver. I am sorry I can't be your IT person. If I gave you further instructions I may do more harm than good. Show this post to anyone you trust with your computer and they will get it, and can be there "near you and live" and you will be fine. Take care. :-) SPINAL

In order to connect it to a network, you need to have the print/scan option installed. If your copier has the print/scan option, you can hook it up with an Ethernet cable and download the print driver from the Ricoh website:

http://ricoh-usa.com/downloads/software.asp?tsn=Ricoh-USA

99% of the time its paper loaded with the side guides of th paper drawer open too wide. -Carl

try and print a test page from the driver and make sure paper is set corectly

Check the paper size dial on the paper drawer. Most likely it is incorrectly set - either size, and/or orientation.

The pressure roller is inside the fuser section of the copier. If there is a flat spot on the roller, you will get those results. It's better to rebuild the whole fuser unit including the bearings and heat roller. That will stop that jamming from happening.

You do have a fuser problem. There are a set of stripper fingers that are supposed to keep the paper from wrapping around the heat roller. One of them may be damaged and is catching the paper. The Pressure roller can also cause problems if it is torn. You need to have the fuser looked at by a tecnician to determine the problem. Hope this helps.

Check the paper size settings and orientation of the driver from the Control Panel, and that match to the paper size in the printer's trays.

Good luck and please rate me, thanks.