No spin cycle

The lid switch controls the rinse and spin cycles.
If the lid switch is bad the cycle fails to advance.
Replace your lid switch.

The problem is the pressure switch has failed or the hose is plugged up, has a hole in it. These are usually inexpensive and are very easy to replace. Here is a video this will walk you thru testing and replacing a pressure switch. You can also enter your model # for diagrams and illustrations of your specific model. All parts come with installation instructions. Not all models are available.

Either your timing motor has broken or the gears that it drives are stripped. The timing motor is easy to replace but if the gears are stripped you will need a whole new dial assembly.

check out the security switch located at the lid , it could be defective , with a multi meter check for continuity, thanks AJ

THIS IS A TYPICLE PROBLEM . BETWEEN THE MOTOR & THE TRANSMISSION THERE IS A COLLECTOR ASSEMBY (THREE PIECE
SET) REAL EASY TO GET TOO EASY TO FIX . ALSO COST EFFICENT

Get a higher quality appliance

something caught in drain pump, clamp hoses and remove pump inspect repair or replace.

If it drains and won't spin you have to replace the direct drive coupling.

if it fills and agitates but stops at the drain/spin portion, it sounds like you have a problem with the lid switch. if it thinks the lid is opne, it will not drain or spin.

Check to make sure your lid switch is working.