Rav 283 remote won't work on my rx-v365

SOURCE: Code for Time Warner Synergy V Model RT-U64CP remote

CODE 301 will turn off Yamaha but I don't have code to turn it back on.

SOURCE: I have HDMI cable from TV to RX-V365. HDMI from

the RX-V365 cannot process the audio from the HDMI input. You will also need to connect a seperate audio input (either coaxial or optical) into the relevant input in the rear of the RX-V365

SOURCE: How to connect the PS3 to RX-V365 to get best

You can connect PS3 video via HDMI to receiver and from receiver via HDMI to TV. But RX-V365 doesn't support HDMI audio, so you have to connect audio separately via SPDIF digital cable. I think PS3 uses optical SPDIF, so you will need optical cable. If you can't find cheaps optical cables in your shop, you can try byuing from ebay ($1-5 max.)

SOURCE: Yamaha RX-V365 unable to receive 5.1 audio from TV with HDMI

If you're expecting multichannel sound FROM THE TV instead of from the source you're watching, it's not gonna happen. TV's are notoriously poor sound sources. This one is no different.

Multichannel TV-related audio is best found at its source - cable / sat / dvd / bd....

I run video-related audio from my video sources directly to my TV and their audio directly to my receiver. Specialization yields best results.

I'd recommend skipping the Receiver for video, too, as it adds a lot of opportunity for HDMI-related incompatibilities and sound syncing problems. The more interconnects in the path, the more distorted it will become and the more opportunities for problems. Plus you can bypass the receiver and listen to lo-fi programming like news and weather through the TV's speakers if you like. Save a buck on electricity.

Just curious, which HDMI on the receiver is connected to your TV? Input or Output?

This note is on Page 11 of the manual:

Audio signals input at the HDMI jack are not output from any speaker terminals but output from the connected video monitor. To enjoy the sound from speakers connected to this unit,
-- make an analog or digital connection besides the HDMI connection (see page 13).
-- mute the volume on the connected video monitor

================
"Check SP cable." -- The unit is perceiving a short circuit. Are your speaker impedances sufficiently high? Disconnect the Front Right speaker and try raising the volume again. The speaker may be blown or the cable shorting.

SOURCE: comcast remote

The volume keys should be working by default, but you may have volume punch through turned on (meaning the remote is sending signals for TV or CABLE volume function no matter what mode you are actually on). To unlock volume control for AUX mode, do the following:
1. Press and release AUX
2. Press and hold SETUP until the remote blinks twice
3. Type 993
4. Press and release VOL-
The remote should blink four times to confirm unlock.