Print unable 52 see troubleshooting and routine maintenance chapter in user's guide

SOURCE: unable to print See Troubleshooting and routine maintenance chapt

Open the top cover and hold the interlock switch on the top right hand corner. Power up and wait for the carriage to come to the center. Shine a flashlight all the way to the right and left and pull out the crumpled paper. You should be able to print again..

SOURCE: troubleshooting and routine maintenance chapter

goes through below link and down the user guide .....

http://welcome.solutions.brother.com/BSC/public/as/as_ot/en/model_top/colormfc/dcp165c_all.html?reg=as&c=as_ot&lang=en&prod=dcp165c_all

Samyfam

• 379 Answers
• Posted on Jul 12, 2010

SOURCE: My printer is telling to me see troubleshooting

This is the Brother definition of error code 4F:
"The head drive voltage has dropped from the high to low level in an abnormally short period." or "The head drive voltage has not risen to the specified level within the specified period in the self-diagnosis"
Causes:
"Piezoelectric ceramic actuator defective (Cracks or rare short)"
or
"Main PCB defective"
No simple fix I'm afraid. You could contact a Brother repair agent but I expect they will want to charge you more than a new machine. Sorry.

SOURCE: PRINT UNABLE 46 SEE TROUBLE SHOOTING CHAPTER IN

i posted few days back solution to this particular problem, please follow these steps:

first, try to establish if this really is full absorbent pad, remove power cable from the back, wait 20sec, press menu/set key, insert power mains - in most brother printer/faxes this will display machine error code. if this is code 46, you are on the money, your absorbent pad is full (not necessarily, only counter is showing it as such in most cases).

we will asssume that counter is showing full and therefore reset it again to zero:

1. after machine code is displayed, key in "80",
2. go down with arrow key till you find "purge counter"
3. type "2783" this should set counter to "0"
4. press "stop/exit"
5. press "9" twice
6. remove cartridges from craddle
7. remove power cord
8. insert power cord back
9. switch on printer
10. insert cartridges back

if that do not work, then maybe really you need to replace absorbent sponge... it is done under warranty and if not technician in service centre.

if you want to do it yourself, remove cartridges, remove fron cover and on the right hand you will have "offending" sponge. either clean it (absorbent, lint free tissue is fine to remove excess first, then few drop of water and repeat draining process with tissue several time, at least till "cake" from the top is removed. best of course will be to replace the sponge with new one.

after that you still need to reset counter. in another way - follow steps...

if you find this advice useful, pleasae leave comment and rate it, thanx!

SOURCE: see troubleshooting and routine maintenance

Error 46 in my printer brother DCP-165-C any help please