My five year old Bosch Axxis WFL 2060 frwasher has started leaking at the lower left corner. Have reduced the amount of soap used and still have problem. Not leaking from water supply hose or drain. Bosch repair came to my house and said they cannot see a problem and will need to take it into the shop to diagnose and fix. Anyone had a similar problem and fix??
Hi. Check the doorseal by lifting the folded lip which faces toward the drum opening. Use a torch and carefully examine the doorseal. It may have a small hole which is hard to see at first.
If door seal is ok remove top of machine and check inlet valve. Turn power off and with your hand examine the inlet water valve. If it feels damp on the solenoid then it leaks from there and finds its way around to the front of the machine though the frame work. This leak happens due to to much water pressure at your laundry taps. If so install a pressure reducing valve before the water inlet hose and replace the water inlet valve in the machine as it is now faulty.
0417362396 Melbourne metro area
Regards Sam
This video will show you how to change a door seal on this
Bosch Axxis WFL 2060 front loader washing machine
we have all bosch repairs in our channel
You can get seals
on eBay
Would suspect inlet valves leaking or small hole in door seal.
SOURCE: Is used Bosch Axxis WFL 2060 with door replaced a safe bet
not a bad price (poss a little bit high) but i would want to see it running on a warm wash first.
I found a pan online.
1,118 views
Usually answered in minutes!
I just found the floor damp in front of my Axxis washing maschine :-( and can't find the leak. I am running a new load right now and will try to observe very carefully to see where it's coming from - just what I need to do on a Sunday afternoon...
My machine is about 7 years old and has leaked on and off. Last week it leaked again and when finished I tipped it up to see if I could figure out where it is coming from. Looked to me like it came from around the bottom of the drum and dripped down from there. I believe I had it on a lower spin speed and a delicate cyle. Would love to hear from anyone who may know what the problem is.
×