How do you change the weight settings from kg to lbs

You use the 'SET' button. With your hand put a small amount of weight on the scales to turn it on. Then use the SET button to switch between lbs and kgs.
I've attached a web link to an owners manual for those scales.
https://download2.medion.com/downloads/anleitungen/bda_md14659_us.pdf

Locate the pound/kilogram (lb/kg) button under the scale near the top of the scale. Select lb or kg weight reading as desired.

Most towing advise works to the 85% rule. As long as the maximum weight to be towed is 'Not' greater than 85% of the vehicles maximum 'kerb' weight, (maximum gross weight).
The Musa should not pull over 1000kg, (1 metric tonne). A braked trailer will allow that weight to rise by about 200kg.

No can do. Cm is distance and Kg is weight. Inches are distance and pounds is weight. Thats like "how can I convert an orange into an apple. RJ

After playing with the remote on this scale for about 30 minutes, I finally found out how to change this display from kg to pounds or stones. Since this scale doesn't come with an instruction manual, I know a lot of people are totally lost. OK, first click the user button once, so that the weight and goal weight show. Then hold down the clock/set button. After a few seconds the kg on the screen will start blinking. Then use your arrow buttons to switch to stones, then to pounds. The lb will show at the top of the display above where the kg was. You can also set your goal weight by pressing the set button and scanning through after setting the lbs setting. Hope this helps!

Hi,

The details are as follows ;-

1. Chassis folded size - 36.6 in X 20.5 in X 8.7 in
(93cm X52cm X 22cm)

2. Chassis weight - 25 lbs (11.4 Kg)

3. Carrycot weight - 15 lbs (7 Kg)

4. Seat weight - 13 lbs (6 Kg)

5. Seat width - 13.4 in (34 cm)

6. Handle height - 37-42.9 in

7. Wheels - Swivel

8. TSC - Yes

Good Luck!!

Thanks!!

Flip over the scale, on the back there is a black button, slide it to pounds.

As listed in the owners manual.

Weight of the Trailer
How heavy can a trailer safely be?
It depends on how you plan to use your rig. For
example, speed, altitude, road grades, outside
temperature and how much your vehicle is used to
pull a trailer are all important. It can also depend
on any special equipment that you have on
your vehicle, and the amount of tongue weight the
vehicle can carry. See “Weight of the Trailer
Tongue” later in this section for more information.
Maximum trailer weight is calculated assuming
only the driver is in the tow vehicle and it has all
the required trailering equipment. The weight
of additional optional equipment, passengers and
cargo in the tow vehicle must be subtracted
from the maximum trailer weight.
The following charts show how much your trailer
can weigh, based upon your vehicle model
and options.
2WD Extended Cab Axle Ratio Maximum Trailer Weight GCWR*
Automatic Transmission,
2.9 L Engine 3.73 3,100 lbs (1 406 kg) 7,000 lbs (3 175 kg)
Manual Transmission,
2.9L Engine 3.73 2,100 lbs (952 kg) 6,000 lbs (2 721 kg)
4WD Crew Cab Axle Ratio Maximum Trailer Weight GCWR*
Automatic Transmission,
3.7L Engine 3.73 4,000 lbs (1 814 kg) 9,000 lbs (4 082 kg)
*The Gross Combination Weight Rating (GCWR) is the total allowable weight of the completely loaded
vehicle and trailer including any passengers, cargo, equipment and conversions. The GCWR for your
vehicle should not be exceeded.

how do I change scale from kg to pounds?

Body Fat Monitor/Scales: TBF-611, TBF-612, TBF-621, TBF-622, BF-541, TBF-560, TBF-572. UltimateScales: 2000, 2001, 2001T. BF-662, BF-555, BF-556, BF-558, BF-559, BF-625, BF-626.
Press the Set and Up Arrow buttons at the same time. Release the buttons, the display will flash. Press the Arrow button to cycle through each weight mode until just the mode that you require is displayed. Then press Set. The display screen will flash to confirm your selection and store in memory.
Note: If weight mode is set to pounds or stone-pounds, the height programming mode will be automatically set to feet and inches. Similarly, if kilograms is selected, height will be automatically set to centimeters.