Subzero 632 cycles from 37 to 50 degrees

Are you asking when was the first one made, they were in production for several years you can use the serial number to tell the date of manufacture

Hi,



I need a serial number and which shelf do you want to replace so I can check to see who has it and where. The serial number is important and all subzero unit and design changes only accrued in some parts. Get back to me and I can search this for you and you can call Subzero direct to get the same information I could. Either way, I am willing to assist you if you want. Thanks..

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

Yes it would be in the drying cycle which goes for almost an hour after the final rinse

That is a very common problem caused by the defrost drain being blocked. Click here=> Leaking refrigerators just what may be happening then here=> Leaking Refrigerators!
Thanks, Sea Breeze

Spray a bit a WD-40 on the hinges and then wipe off the excess...give it a couple of days to work into the hinge...

heatman101

you can check continuity of the valve coil or cycle the icemaker. check the fill tube to the icemaker and make sure it's not filled with ice.

nope. you have evaporator freon leak.

if the ice maker leaking it's easy to replace, or may be just a water supply tube has been moved to the side

Error code 50 means excessive refrierator section compressor run. Possible causes include: dirty condenser, stopped condenser motor, faulty termistor or an evaporator refrigerant leak. If it is a refrigerant leak it usually shows up as frost or water driplets half way down on the back wall. Clear codes by holding the alarm button in for 15 seconds.

you have a leak in the evapator you will have to call a subzero tech to get it changed..