Just bought a kenmore standup freezer at a scratch and dent warehouse. on plugging it in, the temp. control is flashing E 9 repeatedly. it is running at a good temperature but i can't adjust it...any help would be appreciated.
My problem seems to have gone away. I checked the wire bundle connector that goes from the door to the area under the freezer. It may have had a bad connection there. After checking the connector freezer worked fine. Only thing I had to do after was to defrost my coil. I guess in the E9 mode it skips the defrost cycle.
Look online and see if you can find an installer's manual. Sounds like the control board hasn't been set to your model yet.
789 views
Usually answered in minutes!
Bought a 14 cu Kenmore standup scratch and dent sale. Few days later display is flashing "-10 E9". I silence the alarm and it reset. Every couple of days it pops up on display again. Freezer is still cold and nothing seems wrong with cooling circuit.
×