I have a lg fuzzy logic 7.5 kg WF-T755A washing machine that has stopped spinning and also stopped agitating in washing cycle

Question edited for clarity, add maker.

They are a funny little machine. The disc in the bottom is the agitator. My first thought was that you weren't locking the lid down properly, but if it spins, you are. Unfortunately, it sounds broken.

https://www.google.com/search?q=Fuzzy+logic+5.5+kg+top+loader

Manual

https://www.lg.com/au/support/products/documents/WT-H756.pdf

..

This is a 6.5 kg capacity washing machine. I hope this helps.

Cindy Wells

I would call the washing machine engineer for a quote as there are to many things that can go wrong eric

Unplug the machine over night and then plug it back in the morning. this should reset the internal cycle back to manufacturers specs.

This problem occurs because someone may have opened the door during operations and the onboard computer recognized and remembered this, so it is now part of the standard operating proceedure.

it appears the motor's sensors could be going bad on it so the diagnostic computer doesnt know what to do but spin the motor in a spin cycle contact LG for a replacement motor for this washer

This dE error or fault code to indicate that the door is not latching properly. Check the lid or door operation to be sure it's not binding and that the door alignment is correct. Also, check the door/lid hinges to be sure they're not binding. Finally, make sure the door catch is in place and not broken. You may need to replace the door hook/catch or the door lock assembly.

Broken or has come off. Drive belt

I have a LG washing machine WTF655TH, it has stopped working, its full of water, but when you push the one button, it trips, how do i get it working again

hi...I have an LG Fuzzy Logic 6.5 Kg WF-F733PC washing machine & it's stop when 3-4 second start washing, wash and spin led appear also the buzzer bip contibuosly...any ideas?it's software problem....need advice

short answer, its not easy. i believe its run by a gear assembly. i would hire a pro to at least diagnois it.