Missing first letter of each line printing to xerox dc440st

Do you get the problem on copy and print also?

Try cleaning the scanning feeder first and to make sure that there is nothing stuck over the scanning lense alternatly you can try by downloading and updating the updated driver from manufacturer`s website.

Adrian, Xerox PE220 Received fax/ Copy missing top 1 inch of Image
Maintaining print quality
Xerox WorkCentre PE220 WorkCentre User Guide PE220
pe220 pdf
Xerox PE220 Problem not printing Recived fax pls help

disconnect the ferry .

Look in the fault codes, I am guessing you will find a 77-11.
But the most likely cause of that on a DC440 is a bad hard drive.

You will be wasting money buying just a chip. The toner and all is in the cartridge. Normally when the replace message comes on, the cartridge is shot.

Be sure that you have network option installed. On top cover of the printer itself (under the scanner) you can see a floppy drive, can you? OK, then it is capable of network printing. Also parallel (Mini-Centronics) port will work.
You may try parallel printing first, it is easier. Download from
www.xerox.com/support drivers for your DC440ST.

Install driver. Connect parallel port to computer via Cenntronics cable and you'll be ready.

If you want to print from network you must have UNIX printing installed in Windows. You have to create a new port in the printer driver and create a print queue and name it "lp". Port address is also needed. For example 192.168.0.1.

To set up network address on the printer you have to log into the printer as administrator.

Press (key) button on the top right part of the keyboard.
On the touch screen enter: #22222 (hash sign and five 5's)
Enter "Networks settings" "TCP/IP" "network address" "STATIC" "192.168.0.!" for example" "SAVE" "QUIT" and the printer will boot.

You may have to ping for the network address to see if it responds. If the copier/printer prints out a config sheet in five minutes you can check the address and other setting you just did.

If the printer DOES NOT PRINT the config sheet it may be disabled in settings. You can log in again (key) #22222 and enable "print config sheet" + reboot again.

This will require a service call by Xerox.
This maybe broken or worn out gears and even a ciruit board to go out.
Check to see if the parts and labor are included with the call charge.
If it is take the service call and let Xerox repair the machine.

Go to the Xerox website go to support and drivers and DL the newest Driver for the Product

When it boots to 70 percent and faults out, one of 2 things.
If you look in the fault codes, or if one is displayed. If it is a 07-11 then you have a bad hard drive in the network area, or as Xerox refers to it as the ESS module, That is the most likely cause.
Secondly maybe the ESS software is corrupted and needs to be reloaded.
I more suspect the hard drive. It's not an uncommon failure.