Hotpoint wma22 is leaking between seal and door

Have you been wiping the glass off in the door. A buildup of detergent crust on the bottom will cause the seal to weep.

Sounds like you door switch is faulty. You can access this buy either taking the lid off and reaching down the side and removing and changing it or you can remove the wire clip around the door seal and folding it back out of the way and the switch is just there, 2 screws removes it. Should only be about 20 pounds for a new one. Hope this helps

you gotta send the full model number,open the door and look at the very front of dw where the door closes into the machine,usually the tag is on the left side at 9 oclock,first are you positive that's where it's leaking remove the bottom kick panel and see if the motor or anything isn't leaking there too.if it is the door gasket it's an easy fix

The door seal has to be in a proper position completely around the door (including the bottom area of the door). If not, it will leak. Also, there are two black corner baffles/seals (located in each front corner inside the tub area) that may also be the culprit. Additionally, there may be an issue with the float switch assembly that shuts off the water supply prior to the wash cycle. If the float switch assembly is allowing an extra amount of water in the tub, it will cause a leak.

+I would remove the motor and check the brushes for wear.
If they are less than 3 or 4mm long, thet need replacing.
If brushes o/k, then it is probably a control module fault.
I am of course assuming that the washer has drained the water out, or it will not spin.

Hi,
Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101
dafhrw

Sounds like a blocked filter to me.
Remove lower rear panel of washer, remove large black hose fastened to bottom of drum, remove and clean filter inside hose, check pump for blockage at same time. You probably will not need to replace any parts
Please rate my solution.
Thanks.

the spray arm not spining and shut water on the door all the time or the hole in the spray arm is clug

it has a big ring clamp around it. both could be loosen by a philipps screw driver.

tnx 4 using fixya,

drcool

I am not familiar with this machine's model, but in most of the machines the filter is located under the panel in the bottom of the machine (the panel under the front door). You should pull the panel out and you will find the filter there. Before openning the filter prepare a bowl and a floor cloth to avoid water's flooding. Good luck!