Posted on Mar 01, 2009

Nikon DSL D80 with "r02" error

I am using D80 with Firmware v1.11.
Now, my camera has "r02" error and the shutter is able to press, but it is still showing "Err".
When I have press shutter, the message "r02" is shown.
Please help.
Thank you very much.

dodi60 May 12, 2009

DSL D80 with r02 readout: I get the r02 readout as I depress the shutter. Sometimes I get the shot, even sequential shots, but other times there is no response when I fully depress the shutter. I fidget and fuss and then maybe it works again. And then not. Maybe. But always I get the r02 readout when I slightly depress the shutter.

2 Answers

Raziff Iskandar Bin Osman

Contributor 1 Answer
Posted on Dec 22, 2014

Raziff Iskandar Bin Osman

Contributor

Joined: Dec 22, 2014

Answers

Questions

Helped

4239

Points

I had the same problem too, try everthing .. give up.. calling nikon service centre

Anonymous

Contributor 1 Answer
Posted on Mar 17, 2009

Anonymous

Contributor

Joined: Mar 17, 2009

Answers

Questions

Helped

4239

Points

Normally, just removing the lens and putting it again you solve the problem. F-- problem means "there's no lens attached !"

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

1helpful

1answer

My Nikon D80 throws a error every time I try to take a picture

check here....

https://www.justanswer.com/video-camera-repair/5egdi-nikon-d80-flashing-error-f4-5-sounds-shutter.html

Read full answer

Aug 13, 2023 • Miscellaneous

0helpful

1answer

Upgrade firmware for Nikon D80

Confirming the firmware version:

Turn on the D80
Press the MENU button and select Firmware Version from the setup menu. The camera's firmware version will be displayed.
Turn off the D80

Basic Upgrade instructions: for detailed instructions, see pdf files below.

Download and expand the firmware files
Format an approved SD (Secure Digital) memory card in the camera
Connect Camera to computer (in MSC USB mode) or use a SD Card Reader
Copy to the top level of the card the downloaded "A firmware" file
Disconnect camera from computer
Update the firmware from the "Setup" menu
Follow the camera's on-screen menus
Repeat steps 2 through 7 using the "B Firmware"
Re-format Card

D80 1 11 firmware upgrade Nikon Knowledgebase

Read full answer

Apr 03, 2014 • Nikon Cameras

0helpful

1answer

Nikon d80 camera shows err error, when shutter is pressed the amount of shots remaining, shows er07. shutter works, but no picture is taken. Bracketing sign is also on display and wont go off.l

failure of the aperture unit is the usual cause - usually the contacts for the phase switch have come loose from the gear. You can find info on this by searching for the problem on the internet, including how to repair it.

Read full answer

Apr 06, 2013 • Nikon D80 Digital Camera

0helpful

1answer

PG UP ERROR IN NIKON D 200 CAMERA

Is this a D80 or a D200?

If you had a failure during firmware upgrade, then your circuit board is trashed. Send it to Nikon - it requires software to replace.

Read full answer

Mar 18, 2013 • Nikon D80 Digital Camera

4helpful

1answer

I've given up trying to remove the "err" message from my D80 . I've done everything that was suggested ! removed the lens , cleaned the lens contacts , removed the battery and added a new...

"ERR" is camera error. Two items to try:1/ remove battery while camera is ON while waiting for approx 30 seconds, press and hold the shutter release, insert battery and give it a go. 2/ if there is a camera hardware reset button try that with camera ON. There may be a firmware update on Nikon web site, but if you cannot read the memory card, you cannot install it.

www.nikon.com Choose your country/area and go to support

Read full answer

Dec 05, 2010 • Nikon D80 Digital Camera with 18-135mm...

2helpful

1answer

I have a D80 since 2 years and since last 1 week have been getting the 'Err' message. Initially, after referring to the manual & pressing the shutter release button, the camera responded only ONCE. ...

Hi sandeepbhat2, On page 129 of the D80 manual is the factory reset switch. Look on the left side of the camera there is the terminal cover, inside below the USB connector is a small reset button. Give that a try. If still it does not work you should call Nikon.

Read full answer

Jun 27, 2010 • Nikon D80 Digital Camera with 18-135mm...

1helpful

1answer

My d80 gives me an error message r02, even while hooked up to Camera Control Pro. How do I fix this?

Having gone over a month with no response, I assume this is no longer a problem.

Read full answer

May 31, 2010 • Nikon Cameras

0helpful

2answers

While my Nikon D80 is Error 09, can I update the firmware?

Have you e-mailed or called the techs at Nikon with your problem?

Read full answer

Jan 06, 2010 • Nikon D80 Digital Camera with 18-135mm...

0helpful

1answer

I have a constant error message displayed. The

I have the same camera, but never had this problem. I think there's something wrong with the shutter mirror or worst, the sensor. Did the viewfinder blacked out when you press the shutter? I think you need to bring it to Nikon repair shop....

Read full answer

Oct 16, 2009 • Nikon D80 Digital Camera with 18-135mm...

1helpful

1answer

Nikon D80 error msg "F--" and "r02"

Remove the lens, clean the contacts, reattach the lens, and jiggle the lens to seat the contacts. If that doesn't fix it, either the camera or the lens may require service.

Read full answer

Feb 19, 2009 • Nikon D80 Digital Camera with 18-135mm...

Not finding what you are looking for?

View Most Popular

D80 Digital Camera with 18-135mm Lens

Cameras

My Nikon D80 throws a error every time I try to take a picture

Miscellaneous

4,249 views

Ask a Question

Usually answered in minutes!

Are you a Nikon Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual

Related Topics:

Nikon DSL D80 with "r02" error