Red flashing indicator in viewfinder of my Canon XL1E

Contact the maker or distributor as it has failed and you need a new part.

Flashing red light.
Oxidizing Module has failed.
Contact your distributor or GreenTech Environmental for replacement.


The Indicator Light, viewed through the horizontal window on the front of your pureWash has two states of operation . Blue Light - Indicates normal operation of pureWash . Red Light - Indicates the fan or oxidizer generator is not operating properly .

Owner's Manual

Abt https://content.abt.com > documents > PUREWAS...
..

Hi. Based on your brief description of the problem I would think that the camera is failing to focus and the flashing red light in the viewfinder is the auto-focus indicator, make sure that the red auto-focus indicator is positioned in the centre of the viewfinder initially until you have experience of using it (to do this consult your camera manual) focus on a subject that has some contrast ie a red brick wall, grass or pebbles on a beach.

These horizontal lines are vertical flyback lines and would indicate
one or more of the tubes cathode drive circuits are defective.
As the picture is predominantly yellow this would indicate excessive drive to red and green guns. Check the red and green video output stages especialy any clamping diodes.regards from Vintie

That is the temp light for low coolant or over heating.

If power indicator light red and warning indicator red flashing than according to user manual :-
The projector has been cooled down enough and the temperature returns to normal. When turning ON the projector the WARNING indicator stops flashing. CHECK AND CLEAN THE AIR FILTER.
Experience:- 1. if the temperature is very low than temperature sensor maybe misbehave.
2. If anyone fan not working
so please you check fans.
(If lamp or lamp ballast unit faulty than after a time period the lamp indicator light ON not a warning indicator. I experience many times if any fan in projector are broken or jamed the temperature light if present otherwise warning light ON or flashing)

It's the warning to replace the backup battery which is housed behind the main battery.

The flashing "boat" in the middle of the viewfinder just means the button battery is dead. Camera will still work. It's the little pull-out light grey plastic thing that's next to the heel of your right hand when you're using the camera normally. You need a CR2025 cell.

ive gt to use it recently and it woot the canovision E100,hardly been used i went to use it and it wouldnt come on , there is a red light

Hi

The camera may have moved when the picture was taken. Try steadily squeezing the button intead of a quick press.

2.Try using a tripod, this could fix the blurred images.

3. faster shutter speed will be needed if you need to hold the camera, and cannot use a tripod.

4. Main reason for the lines could be that the subject is to bright.
A vertical bar of light(red, purple) appears on the LCD monitor/ in the viewfinder This is a normal occurrence in devices containing CCDs (Digital Cameras) and does not mean a malfunction. (This red bar of light will not be recorded when shooting still photos, but it will be recorded when shooting
movies.)

Solution to the last point would be to try and switch of the flash if it is in use. Turn the ISO setting (50, 100, 200) to a lower one as well.

Hope that helps.

I don't think that this is a defect. I own an A60 and there is an horizontal line running through my viewfinder. I use my LCD screen more often then my viewfinder, so I've never seen the blur. However I'm pretty sure that your camera is fine.