Dial tone is active as I'm dialing, callers cannot hear me speak

1. Pick up the home phone receiver, wait for dial tone, and dial *94. You'll hear 3 beeps followed by dial tone.
2. Enter the number of rings you want (between 2 and 9).
3. Listen for 2 confirmation beeps and hang up.

After you enter *67, you hear the dial tone. Dial the outbound number. Your caller ID is not presented on the receiving end.
After you enter *82, you hear the dial tone. Dial the outbound number. Your caller ID is presented on the receiving end.

Hi,
the phones earpiece which you can use to hear the caller calling you is faulty and needs to be replaced.


Take care.

The switch that the handpiece activates is not working. Could be optical, magnetic or physical. It may need cleaning, adjusting or a wire connection repaired. Also check the curly cord and its connections between the handpiece and telephone.

Headset says ringer off, cannot hear dial tone

You have a feature active on your phone it's more than likely a call forward feature which would redirect you calls. The broken dial tone or stutter dial tone is an indicator a feature is active. Contact you system admin for the clear all feature code and the clear all call forwarding codes.

constant dial tone and cant dial out or receive calls

Activating Call Forwarding

You can activate Call Forwarding whenever you want your calls to be sent to another phone, including a mobile phone. Once activated, all your calls will be sent to the forwarding number you request. Each time a call is forwarded, you will hear one short reminder tone on your home phone, but you will not be able to answer the call from your home number.

1. Lift your telephone's receiver and listen for a dial tone.


2. Press *7 2.
In some areas you must use 72#
Dial 1172 on rotary or pulse-dialing phones.


3. At the tone, dial the telephone number where you want your calls transferred.
You will hear the number you entered ring. When the number is answered, Call Forwarding is activated.


4. If the call is not answered or the line is busy, hang up and call the number again within two minutes.
You will hear two short tones telling you that Call Forwarding is activated.


5. Hang up the receiver.

Deactivating Call Forwarding

Turn Call Forwarding off when you want to receive calls on your home phone.

1. Lift your telephone's receiver and listen for a dial tone.


2. Press * 73.
In some areas you must use 73#
Dial 1173 on rotary or pulse-dialing phones.


3. Listen for two short tones.
Call Forwarding is now off and you will receive your calls at your home number.

phone says move closer to base

Refer to your manual. It may be under RX(recieve settings). Go disable FAX/Tel SW and make sure it is fax mode only