Freeze does not cool down. Model kscs25fkss02

Kitchenaid has a dimensions guide for the KSC25FKSS refrigerators on their support site: https://www.kitchenaid.com/service-and-support/manuals.html . The depth depends on the handle style; these models are 35 1/2" W X 27" or 27 1/2" D X 71 7/8" H. The link to the document is https://www.kitchenaid.com/content/dam/global/documents/200312/dimension-guide-2221514-D-KA.pdf .

I hope this helps.

Cindy Wells

You might be low on gas in your compressor. If compressor comes o b but doesn't cool chances are gas is too low. Make sure coils are clean and air gets to the back of the unit

It sounds like the water pump is not working. Google your make and model with the words 'water pump repair' after it, if you want to try repair yourself. Otherwise take it to a mechanic you know and trust

Never heard of the wrong anti-freeze. You're best bet is to check the temp sensor and replace it. It is what tells the system fans to "cool down"

Here is the filter that you need for the fridge. Links below. Model # is 4396508

http://www.filtersfast.com/4396508-Whirlpool-Water-Filter.asp

http://www.fridgefilters.com/whirlpool-water-filters-4396508.html?cust-title=Refrigerator Model KSCS25FKSS0 uses filter 4396508

http://www.amazon.com/Whirlpool-4396508-KitchenAid-Refrigerator-Non-Cyst/dp/B0009793KC

http://www.google.com/#q=kitchenaid+4396508+water+filter&hl=en&prmd=ivns&source=univ&tbm=shop&tbo=u&sa=X&ei=936zTY_yCYLSsAPh5PXcCw&ved=0CE4QrQQ&bav=on.2,or.r_gc.r_pw.&fp=84f9a73b468239aa

you can use an all make all models anti freeze, it will mix with the dex-cool but i suggest that you flush the dex-cool out of the system then refill with an all make all model anti freeze.

Here is a link to the owners manual

/Use%20and%20Care%20Guide%20-%202221544.pdf

if you want to narrow it down a bit-go to radio shack get some freeze spray.remove back-lay it down -use a blow dryer to heat each board till it goes out-then use the freeze to cool each board down till it works-do it a few times to make sure you get the rite board---now go to shopjimmys.com to find your board

let someone check the pressure of you FREON that is one of the problem need to look on

That just worked for me too. Hold the power freeze and power cool buttons down at the same time and it will reset it after a power surge. All I had working was a light inside the door and a blinking green light on the display panel.