At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Ronald is right on. I just replace the door gasket on a Whirlpool. The power button worked , but I only got two beeps when pressing start. I opened and closed with door with gusto and it is working fine.Ronald is right on. I just replace the door gasket on a Whirlpool. The power button worked , but I only got two beeps when pressing start. I opened and closed with door with gusto and it is working fine.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It sounds like the control panel is locked. See if one of the buttons says lock and hold it down for at lest 3 seconds. If the control is locked, that should unlock it. Its a child safety feature.
Locking controls
The Control Lock prevents unintended use of the washer. You
can also use the control lock feature to prevent unintended cycle
or option changes during a cycle. When CONTROL LOCKED is
lit, all buttons are disabled. You can lock the washer while it is
operating.
To lock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds.
The CONTROL LOCKED status light glows.
To unlock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off.
check the solenoid on the front chunk these vehicles have had a lot of problems with these solenoids. have personally replaced about 10 of these on 98-02 models.
Most likely your laptop is going into sleep mode. Lots of them do not like sleep mode if nothing happens when you push the power button try to hold it down for about 5 sec. your computer should power off and then you can start as normal. If this problem persists change the options in your control panel to turn sleep mode off. That should solve it.
Press and hold the "End of Cycle Signal" button to lock or unlock the control panel. The instructions should be printed directly below this button. I hope this helps you.
Same here nothing happens when I push start button. Outlet and breaker are fine. I think its the computer (mother board).
×