Prevention ws-820 wrist monitor. Keep getting error -3 message and nobody is moving. Restarted . Keep getting the same error code. Any ideas?

he wristband has not been put around the wrist correctly. Put the cuff around the wristcorrectly and try again.
Or
This message may also appear in case of a malfunctioning cuff or pump. If this error message continuesnto appear, take the appliance back to your dealer for repair.

If you need further help, reach me via phone at https://www.6ya.com/expert/kelley_9a924afdf232bd4d

Noisy kerchoff sounds. Need to put wrist at heart vertices level.

There are 3 things can cause the EE error code.

1. Cuff was placed incorrectly. Wrap cuff snugly around your wrist 1" above the heel of your left hand.

2. Moving or talking during measurement. Measure again keeping your wrist steady during measurement.

3. Shaking of the wrist with the cuff on. Solution is the same as # 2.

If you continue to have a problem with the cuff, contact HoMedics Customer Support 1-800-466-3342.

I hope this info was helpful and thanks for choosing FixYa.

Janie, you didn't mention what brand BP Monitor you have. But, if you have a Walgreens - HoMedics Wrist Monitor, the E3 indicates Error determining measurement data. In which case you should measure again. This particular error can be caused by movement of the arm, hand or wrist during the testing function. So, remain very still and keep you arm/wrist at heart level until the testing is completed and the cuff deflates.

Hope this helped you. If you have the Model I listed above and this continues to occur, contact HoMedics Customer Support 800-466-3342

820 Self-diagnostic error: CPU

Symptom:
• An unexpected exception or
interruption occurs during the self-
diagnostic test.
• An error is detected in the MBU.

Possible Cause:
• Defective controller
• Defective firmware
• Loose MBU jumper


Code 820
MBU error (The jumper is loose.)
Set the jumper (on the MBU) correctly.
The following codes are displayed:
• SC: 820
• code: 612
• detail: 40000000

According to the Owners Manual, the EE Message shown on the display or the blood pressure value is displayed when an excessively low (or high) reading is detected OR as a result of one of the following:

1. Cuff has been placed incorrectly. Solution: Wrap cuff properly so that it's positioned correct.

2. Did you talk or move during measurement? Solution: Measure again. Keep wrist steady at heart level during measurement.

3. Shaking or moving of the wrist with the cuff on. Solution: Same as # 2.

NOTE: Be sure the cuff is placed exactly as pictured on the face of the box, 1/2" above the heel of the hand.

EE means one of 3 things:

1. Cuff has been placed incorrectly. Solution: Wrap the cuff properly so that it is positioned correctly.

2. Did you talk or move during measurement? Solution: Measure again. Keep wrist steady during measurement.

3. Shaking of the wrist with the cuff on. Solution: Same as # 2.

You are spot on. It is a possible indicator for Atrial Fibrillation or AFIB. If you suspect that you have AFIB, you need to get your doctor to prescribe a digixon product, AFIB is very dibilitating and can cause death. Take care and seek help.... Guy

Irregular Pulse Rhythm

Deflation Error - Movement or talking was detected during measurement.

Turn off the power and make another measurement while being quiet & still.