Dell 1704FPTt 17" TFT LCD Flat
I used to
repair LCD monitor from Dell. There are 4 screws for rear panel and no screw for
front frame. If there is no visible screw, you have to look for
"capped" screw holes (little covers that fit flush with the case to
hide the screws). If you don't see these neither, this must be a tension fit case.
So, face the screen up and look for "rectangular hole" on the side
edge (usually at the bottom edge of the screen). This will be a challenge to
open without breaking it. You'll need a very thin flat screw driver and wedge
it into that narrow rectangular hole. You can use any prybar if you don't have
screw driver. It is not too deep. You may stab something important inside and
pry it. Once it starts to spread, start sliding it along the seem and you
should feel the tension tabs start "popping" open. Continue to work
your way around until it's off. Hope this will help you to get the rear panel
off. If there is anything I can help you with, feel free to let me know.
Thank you,
Can't find monitor driver for my monitor. The manufacturer's website seems to be down.
Cant find Driver for E17t6W.
×