What does F35 error code mean on Whirpool Duet front load steam washer
Sud= The unit has sensed there is too many suds in the unit it will
flush and pump out for 5 min and restart on its own..This is caused by
too much soap use..
From the book :
SUD Code=
If too much detergent was used:
—Run the unit through a Rinse/Spin cycle.
—Run a Normal cycle without adding any detergent.
This should clear the unit of the excess detergent.
1. Check the drain hose and make sure it is not plugged
or kinked.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the drain pump,
pressure switch, and Central Control Unit (CCU).
4. Check/clean drain pump filter of foreign objects.
5. Plug in washer or reconnect power.
6. Check drain pump.
7. Check the pressure switch.
8. Verify CCU operation by running a Diagnostic test or any
cycle.
I tried that fix and it did not work. The next step was to replace the analog pressure sensor, $168 with next day delivery. That fixed the problem, but the price is a ripoff and less than 4 year old washer should not need any repairs.
The part is a small unit with a small electronic circuit with a pressure switch.
I bet their cost is less than $10
1.Remove three screws on the back of the top.
2. Slide the top forward about half an inch and lift off.
3. the switch is mounted on the upper right.
4. Remove it from the side and slide the black cover up to make it easier to unplug the connector,
5. Remove hose.
6. Plug in new sensor and connect hose.
7. slide cover down and install unit.
I tried that fix and it did not work. The next step was to replace the analog pressure sensor, $168 with next day delivery. That fixed the problem, but the price is a ripoff and less than 4 year old washer should not need any repairs.
The part is a small unit with a small electronic circuit with a pressure switch.
I bet their cost is less than $10
1.Remove three screws on the back of the top.
2. Slide the top forward about half an inch and lift off.
3. the switch is mounted on the upper right.
4. Remove it from the side and slide the black cover up to make it easier to unplug the connector,
5. Remove hose.
6. Plug in new sensor and connect hose.
7. slide cover down and install unit.
×
Hello & Welcome to FixYa
F35 error means that there is some sort of issue
with the steamer electronic board and analog pressure sensor has gone bad.
Check that the hose is firmly attached with the washer and is not blocked. You
can also check the water level pressure switch operation. Please get back to me
if you have any other questions.
Kevin
Hello & Welcome to FixYa
F35 error means that there is some sort of issue
with the steamer electronic board and analog pressure sensor has gone bad.
Check that the hose is firmly attached with the washer and is not blocked. You
can also check the water level pressure switch operation. Please get back to me
if you have any other questions.
Kevin
5,430 views
Usually answered in minutes!
washer flashes f35 and sub i have what sould i do
How do I identify the pressure switch?
Whirlpool duet DRIER flashing error code F01
whirlpool duet F35
What does the F20 error code mean and how do I fix it?
the motor runs but the machine does not spin or clean
this is a whirlpool duet front loader garment and wash light are flashing
×