EFO, E10 error Message

Good Morning Laurencemcna,

I understand that your Frigidaire Affinity washer, model# ATF6000F, does not start, but instead, gives an error code or "PAU" message. Please try resetting your appliance, by either unplugging it or shutting the power off at your home's circuit breaker, for 3-5 minutes. Restore power, and try to start your washer again. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful.

-Best Regards-
WP

E10 means that your cold water is coming in too slow, disconnect the cold water hose and check to see if the screen on your washing machine is clogged. If the screen is clean and the hose has good pressure then you will need to replace the water valve on your machine--- this is the piece that the hoses directly connect to.

Here could find additioan sample guide details: fixed-frigidaire-affinity-washer-gives-e10-error

Hope helps.

E10/EFO error code is an indication of a slow fill, took to long to fill, no fill or the fill water could be siphoning out the drain hose as it's filling with water.

Check to make sure that the drain hose is not stuck too far down the stand pipe and causing the water to siphon out. Check the cold and hot water supply to the washer for any restrictions. If you have a slow fill remove the hoses from the washer and check for restricted filter screens in the water inlet valve. Check for any restricted hose screens too.

efo enter prblem what is the problem

1 Beep/E10--Error: Water doesn't enter Cause: Water supply problem, Check kinks and faucets
1 Beep/E10--Error: Water leaks Cause: Water connections loose,household drain clog,oversudsing. Correct problems.
1 Beep/E10--Error: Dispenser drawer is open Cause: Washer will not operate if drawer is open.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

the cycle is not rinsing --- there is a hose inside that is about 1/4 " thick that gets damaged --- the unit that it attaches to at the top of the unit also needs to be replaced--- also clean out the drain unit----- parts can be found on appliancezone.com

I have had the same problem on an AEG. The problem it refers to is that there is not enough water entering the machine. Either the water pressure is too low or there is something blocking pipes/filters. Hope this helps

it sounds like your brushes are gone you need new brushes in the motor

It is simple. The wrong soap or too much soap will caused EFO to flash. I overfilled the machine with soap by accident. It started flashing with EFO and I went nuts. What could be wrong with it now?! Too much soap or not the right kind of soap will cause this problem.
Plus, I found a sheet of paper that gives the codes.

This is better than when the strainer plug gets filled up and you have to take the machine apart to clean the little strainer.