F5 - E0
Door switches do not agree (condition exists when door switch is closed
indicating an open door, and latch switch is closed indicating a locked
door)
1. If door latched:
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61
F5 - E1
Self clean latch will not lock
2. If door not latched:
Disconnect power from unit.
Check wires and connectors from control to latch switch, then from
latch switch to control. If no damage to wires and all connectors okay,
proceed to step C.Repeat steps A and B for door switch.
3. Measure door switch (door open = switch open small low voltage
terminals). Replace switch if defective.
4. Measure latch switch (unlatch = switch open, CAUTION - oven light
contacts are closed). Replace switch if defective.
5. If corrections are made in any step, reconnect power to control.
Press and hold any key for 1 minute to clear R failure code from memory.
F2 will appear. Press CANCEL and observe for 1 minute to ensure
operation is correct.
6. If failure remains, disconnect power and replace control.
Note: Applies to all F5-E... codes.
I hope this works for this site. HERE is the whole magilla.Just in case that don't work copy and paste this:
http://www.appliancepartspros.com/repair...
×
2,339 views
Usually answered in minutes!
Where's the cancel button on a Whirlpool Accubake Oven?
i was getting e0 and e1 with f5 -- searched them, found these tips, played around with the latch and held cancel for a minute. looks like it worked. thanks!
Oven will not stay in clean mode and give a code of f5
i have e1 f1 error code.
×