My lg wm1832cw washer was in spinmode when it made a bam noise and lost power. I had to change the board ans when I did the upside down f and e came on. I changed the thermistor but am still getting the code. Any sugggestions?

SOURCE: lg wm1832cw front load washer

One of 2 things may be causing the loud noise.  Either the rear bearing on the drum has failed and will need to be replaced (very expensive) or the drain pump has a bearing problem and is making a very loud noise when it is draining (not too expensive).  Either way, you will need a qualified LG technician to diagnose and repair the problem.

SOURCE: Need code/s for LG WM1832CW to have washer do a spin/drain only

1. press POWER button to turn om.
2. press SPIN SPEED button only.
3. press START/PAUSE button/

SOURCE: LG Tromm washer WM2688HWM tE error code. Very easy

LG Tromm Washing machine te error. The manual says to call for service. Not much help there. The reason for the error is the thermistor circuit (resistive element that becomes less resistive as it increases in temperature). The thermistor acts as a heat sensor. In many cases, the error occurs because the wireing harness is too tight at the bottom of the drum and one of the wires in this circuit becomes disconnected with all of the movement of the drum (unbalanced load, normal cylcing etc).

1. Unplug the washing machine from the wall. The thermistor circuit is at line voltage (110 in the U.S.) and it will bite! So do this first before proceeding.

2. Move the washer out so you can get access to the back of it.

3. Remove the stainless panel (the one that is not painted, it is large (aprox. 16x18 inches). It is held in place by 4 phillips screws.

4. Locate the thermistor connection block near the bottom of the machine, at the center of the wash drum. It is the small white connector that has two wires running to it. One wire is dark blue, the other is light blue. Insure that neither wire has pulled out of the connector. If either of them have, repair the connector and provide enough extra wire ( aprox. 2") to provide cable relief.

5. If the cable connector and wires are ok, there are other solutions here that recommend either cleaning or replacing the thermistor.

Good luck to you.

SOURCE: Error code LE on LG Wm1815cs

Error OE appears after about 10 minutes into a cycle. "OE" in the manual says filter clogged....we have checked & cleaned all of the lines/filter. Now we hear a light humming instead and the washer isn't doing anything...

Mike

• 166 Answers
• Posted on Jan 20, 2010

SOURCE: My LG WM-2277HW front load washer has an error

This is a water overfill condition and many things can be causing the issue.
Leaking water valve.
Plugged water lvl. switch hose.
Problem with the main computer.

A service call may be needed.