My lcd computer freezes very sudden

Faulty Thermostat or thermistor sensor.

Perhaps the computer cannot play the game properly because your computer lacks in some requirements.

• Hi, this freezing of the Computer all of a sudden can be the cause of a number of things; first have you "downloaded any new Software, Toolbars, or changed any Programs? Next check to see "How much Memory is available to you." Go to and open the Computer Properties, if there is (more Used Space than there is Free Space) than "I suggest you do a [Disk Clean-Up] from the same location. Next, when was the "Last time you preform a "Defragmentation of the files, this can slow down the Computer's performance aswell." Backing up your Data and Files is another way to free-up space; this can be perform by (Sheduling Tasks), go to the "Control Panel.' for this task. If any of these things do not apply, then the next thing I suggest is to "perform a System Restore," this will restore your computer hopefully, back to a Time or Date prior to the problem beginning. The [System Restore] can be performed from the Control Panel. "If this information to a solution was of help, rating it is appreciated, thanks

My VX924 did the same thing but now displays nothing and power switch light just blinks. According to an answer listed on previous page, it may have bad capacitors. I may have to take a look at them. Viewsonic repair facility examination of this monitor runs $70.

scope the power supply feeding the microprocessor, sounds like it has ripple caused by a leaky electrolytic capacitor.

Change the Ram

Normal 0 There are a number of things that can cause the camera to freeze up the computer.
First I’d check to see how much memory is installed in the computer. It takes additional memory to operate the camera.
Hope this helps. Bud

Use VIRUS checker or best thing is

UNIBLUE SPYERASER

your lcd need a tech who could help you to repair the power failure.

Is this monitor and LCD flat Panel? If so this is due to a bad power supply, an inverter board going bad or LCD backlight bulb blown. When the backlight goes bad it gets just enough power to start up, but when it is on for a long period of time it goes black because the bulb is not stable enough to hold the charge because it is going bad. These bulbs can be changed, but they also can be costly!