Creda Washing Machine Detergent Dispenser not emptying

Dimensions Depth 58.5 cm Height 85.01 cm Width 59.51 cm 23 x 33.5 x 23.5 inches
Creda Simplicity 1000 W100FW Washing Machine Excellent Condition No Use...

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

This is probably due to excess detergent blocking the feed into the machine, try removing the tray and washing it in the sink. If this works I would rinse it out every month or so, this could be done in the machine by not putting detergent in the dispenser and putting the machine on a short wash cycle. Hope this helps.

None. The machine will do cycle as usual.

Hello,

There is an article of clothing stuck inside the dispenser housing. Remove the top and the housing to get to the hose and clean it out. Very common issue, I know this unit very well.

When the machine starts to wash water passes into the detergent dispenser and carries the detergent into the drum, if the detergent outlet is blocked, or resticted, this will cause the water to leak out of the dispenser.

Check the dispenser to see if an accumulated crust of powder is clogging the outlet holes, most dispensers are removable for cleaning, check your machine instructions for details.

Tim, the machine probably has a double water valve. One for detergent and one for softener. I'd check that they're both working.......Nomess

it could be either a leaking water inlet valve or the pump is not emptying all the water from the machine and when it goes in to spin centrafugal force forces water back up the filler pipe

Filling laundry detergent and/or additive 
dispensers 
Dispenser I: (RIGHT SIDE)
Detergent for soaking agent. 
Dispenser II: (LEFT SIDE)
Detergent for wash, stain remover. 
Dispenser 2: (MIDDLE)
Cleaning product, e.g. fabric softener, fabric 
conditioner (do not fill above the lower edge of the 
insert 1). 

fabric softener This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

The detergent dispenser is located above the detergent drawer. A water pipe is connected to it and water entrance and distributed to drawer's cells (following the programmed cycle) by a lever's movement (part of the dispenser). The lever movement is controlled by two solenoids that received their power from the timer. By opening upper machine's cover you will have an access to the dispenser. Disconnect the power cable from the machine before moving to next test !!!! Look first that they are not any disconnected wires. Move manually dispenser's lever and see if water running to all cells (depend on your movement). In case it doesn't work properly remove the unit from the machine and try to clean it (I hope it will help, otherwise you should replace the unit). In case it works properly (manually) - you should test by a multi-tester solenoid's resistance. the one that doesn't have a resistance measurement should be replaced. Good luck !!