Circuit board on a black&decker ps 150 battery charger

To buy this kind of battery charger, go online. Here are some links:
Ebay
http://www.ebay.co.uk/itm/2x-18V-1-7A-Ni-Cd-Battery-for-Black-Decker-EPC182K2-EPC186BK-EPC188BK-/301027805247

Amazon
http://www.amazon.ca/s/?ie=UTF8&keywords=black+decker+battery+chargers&tag=googcana-20&index=tools&hvadid=37922783346&hvpos=1s3&hvexid=&hvnetw=g&hvrand=8378677556230101&hvpone=&hvptwo=&hvqmt=b&hvdev=c&ref=pd_sl_6ohdvz1qs9_b or Canadian Tire, Home hardware could be a good source.
Good luck!

it is probably the brushes on the motors are wore out or stuck and not making contact. pretty much junk unless you feel confident enough to attempt repair.

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

look at your charger,on sticker you have the power it drain.

could be either one. Have you tried another battery? If not I would recommend taking BOTH in for inspection. They have a scanner that can detect if the battery has a problem. If you need to find a service center close to you go to dewaltservicenet.com and they have a locator. Let me know if you need more assistance.

check voltage on prongs of charger your transformer my have died

Porter Cable has not offered a replacement for their poorly designed 19.2V chargers. I had the same problem and happen to like my drill and circular saw. I found a universal charger called a model number CHUN-2420. Google it--I got mine for $27 plus shipping. All you need to do to make this work is splice 3 wires.

My charger is a PC model 8624, so the instructions might vary slightly between the chargers. Remove the six screws on the bottom of your PC charger. Remove the bottom section. Remove the screw(s) that attach the circuit card to the plastic housing. Disconnect the 3 pin white charging connector from the circuit card, and cutoff the connector. Discard the circuit card and power cord. Cut the 3 conductor (red/yellow/black) cable coming out of the Chun-2420 approximately 2' from the charger. Splice these three wires to the three wires in the charger housing that connect to your battery. In my situation, Red/Red, Yellow/Yellow, White/Black. To verify, red=positive, black/white=negative, yellow=temperature sensor. Wrap the red/yellow/black cable with electrical tape where it exits the PC charger through the power cord hole. Re-attach the bottom.

In March, 2006, Black & Decker purchased Vector Products, Inc. Since the acquisition, Black & Decker has assumed the manufacturing of all Vector products. For customer service and warranty information for Vector products, please contact Black & Decker Customer Service. www.blackanddecker.com/CustomerCenter/Default.aspx

My charger has a fuse located on the circuit board inside the unit....when mine stopped working, it was the fuse...replaced it and it is working fine for one battery, the other blows the fuse every time....bad battery.

Open it and look for a fuse, then go buy a new one (my Ryobi charger didn't have a fuse)

the largest is the 24v CMM1000. now the circuit board for the said model are hard to get. but upgrade are available & convert it to CMM1200 model. convertion kit includes instruction how to, a wiring assy & a charger.