Need a User Manual for Candy CMD146 Type LCE2

Both problems could be related to a blocked drain, from what I can see in the manual. 3 Things to check -

1. Clean the filter - instructions can be found on age 24 of the manual.
2. Check the drain hose has no kinks/securely fitted.
3. Check the drain trap under the sink for blockages. Make sure waste water can drain away freely.

Keep a couple of old towels handy when checking the drain filter, if water is trapped in the machine, it will flow out of the filter housing when you remove it. Try a drain cycle for a minute or two before you remove the filter, then turn the machine off, and check it. That way you'll have drained as much water as it will allow.

The manual can be found here- http://service.candy-domestic.co.uk/manuals/pdfs/CNW156.pdf

you will need to replace the brushes in the moter ok

How do u turn the heat down when drying clothes?

please try if this link helps.:

http://safemanuals.com/user-guide-instructions-owner-manual/CANDY/CDW%20254%20SXX-_E


www.espares.co.uk/parts/???dishwashers/???candy/???cdw254-uk/p/1083/775/0/???677466

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
,,,,.

Yes it could be the heating element. However, it could be the thermal overload switch. This is located under the top of the machine. Bypass it to see if works. If it does, then it is the switch. If not, check the element. It sounds like this is the element with the 2 yellow wires.You will need to pull it to visually check to see if it is burned in 2.Check the element first since you have easier access to it. Let me know how this works.

Is the dryer electric or gas? If electric, the heating coil may have burnt out. If gas, check gas supply and then gas ignitor. Good luck.

This machine has selfcondensing system. The condense water is beeing pumped out with the cooling water. The watertap MUST be open during drying. It also may be caused of overloading. The most W/D combos is just able to dry just the half of a full load in one time.

more info. i.e is it pumping out water????