My Whirlpool Cabrio washer keeps reading LD and won't restart or nothing. It has water in the tub. I tried unplugging it and starting over, but it won't do anyhyingMy Whirlpool Cabrio washer keeps reading LD and won't restart or nothing. It has water in the tub. I tried unplugging it and starting over, but it won't do anyhying
The ld code means a long drain, what you probably have is something blocking the drain pump.
you can get to the drain pump from the back of the unit and it will be the pump on the left as you face the back.
you will need to remove the hose going into the pump and be ready for water to come out. sorry but you need to check inside the hose as there will be something blocking it. like a coin or some lint or a small sock.
when you get the item out of the hose then it should work again. you do not need to reset the control. once it knows the unit is draining properly it will be ok.
1,393 views
Usually answered in minutes!
The noted solution fixed my problem. You'll need a wet-vac to empty as much water out of the tub before removing the hose ( I have a 10-gal). It was also very helpful to have a spill/overflow tray that the washer sat on when the pump hose was removed. This captured the water flowing from the hose while the wet-vac was sucking the water out of the tray. Never got a wet spot on the carpeting in the laundry room using this method. The rubber hose between he tub and the pump was a bear to get back on. I had to switch to band clamp as I couldn't get the hose back in place with the existing clamps. Good Luck!!
serial number wtw7600xw2
bearings very noisy on cabrio washer
×