How to light oven with electric power off?

Possible locations shown in article at the web link below:

https://www.hunker.com/13409112/how-to-find-a-model-number-on-a-magic-chef-oven


How to Find Model Number on Magic Chef Oven Hunker


Quoting the link above:

Step 1 Open the oven door. At the top, left-hand corner of the open oven, locate the model number tag.
Step 2 Check under the burners. Lift each burner on the stove off to see if the plate is underneath. Do this if the plate is not located on the inside of the oven.

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101

Hi, the F2 code on the Magic Chef Oven implies that the Oven temperature is too hot.
The solution is to replace relay board, if present, or oven temperature sensor (RTD). Check sensor harness...

Hi,
The baking element is probably the problem...

Check out this tip that I wrote about this problem...

http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating

heatman101

25 yr old oven...........so I bought a new one with a few blemishes for $200.

I'm not familiar with this oven, but it ought to have protection against this kind of exciting burn-out.
This could be a fuse: find it and replace it, or it could be a circuit breaker: look for a reset button.
As I said, I don't know this oven; this attempt to help is based on the general idea that it ought to have some built in protection.

You can download it here but you need the right model #.
http://shared.whirlpoolcorp.com/product_literature/search.jsp?siteCd=MCF
As for the temp adjust it is best if you get an repair man out to do that.
Good Luck

hi .thanks for the question . A very common problem with gas ovens replace the igniter thanks the appliance doc

hi. Thanks for the question. The problem is with the igniter . Replace it it is located under the floor of the oven .thanks the appliance doc

Yes this is normal. you can use that burner to keep things warm without turning it on, saves energy.