Bosch Nexxt wfmc3200uc will not spin or finish cycle. It drains a little water at the start of the cycle then you hear a little clicking noise. I have drained it out and tried again but no luck. any help here would be greatly appreciated. thank you.
I have the same problem not going into a wash cycle and get the "ready" message on the screen. It only went through a cycle with no clothing.With wet clotches back in, I put it into spin cycle manually and only the drain pump went on then back to ready. I tried this several times in a row and it finally went into spin cycle after draining each time before. I opened the drain clean out and got all of the water out(about 10 cups) with a wet dry vac. Now the machine goes through a cycle. The problem is intermittant and very common with this washer. I haven't seen a definitive solution yet. It seems to be an engineering problem with the drain and sensors.
Replacing the motor module solved the problem
Thanks Jeff
Motor module as in the printed circuit board or the motor itself?
×
On the lower rhs is a clean out door, use ascrew driver to spin the door loose and clean out the pump behind the door.
1,036 views
Usually answered in minutes!
I have already done that and the same problem persists. Anything else I can try. Thanks
×