I can't get the camera to get out of cassette standby. I have the setting on camera, but it stays in standby.

The loader motor turns a belt to draw the tape out of the cassette. Probably needs replacing.

theres could be some part have still contact to the cover..

try to insert again the tape and eject it again, to remove that thing have contact to the cover..

Post back again

This will require service / repair at shop.

Are you putting the cassette in the correct way round ?

Im going to guess that if you try turning it on, sometimes you hear a "click" and nothing then the problem persists over and over until it finally turns on? If so, it's a problem with the power that "jumpstarts" the screen. Worn out capacitors on older models don't hold the necessary charge it takes to "start" the inverter that powers the screen. Once those start to go, it's usually bye bye for the tv. That is IF this is your problem. Let me know. Sometimes it makes hissing or cracking noises along with it. hope this helps!

Nobody answered this? Well that's disappointing. I have the exact same problem now at the end of 2018 six and a half years later. Searching on.

Whenever a television starts doing this the motherboard/main board and or power supply is usually at fault. The power supply can usually be rebuilt for around $150 depending upon the knowledge and skill of your local television repair shop. To replace the parts is usally more expensive then it would be to purchase another television ($300 and up). Are you sure this is the model number of your television because this model number is not for a CRT television. For troubleshooting you can unplug it overnight to try and power cycle it but it sounds like your problem is beyond doing any type of power cycle to get the television back going again. It would need the repair shop or to be discarded for another.

Wanna run that model by us again? "NEX-D555"? Can't play fast and loose with alpha-numeric info. I don't suppose you have the manual either.

Whatever it is try a search engine for "(exact model) manual".

Pressing the POWER/STANDBY/ON control would be one way to turn it on.

I had a similar issue where the tape bay would not lock in and engage the motor mechanism to load the tape. I removed the battery from the unit and let it stand for approximately a minute then reinserted the battery. The tape drawer closed first without a tape then reopened with no issue. I then inserted a new tape with no issue. I guess it needed a hard reboot.

I have the zr850 which I have used less than a dozen times, and it does the same thing as you describe. Was told by canon tech people to try a maxell brand tape and a head cleaner tape. Have not tried their sugestion yet. camera is 3 months old.