MY DRILL GOT STUCK - Dewalt 18v Battery Hammer Drill Dcd950 Dc925

Lock the chuck and undo the collar. Lock is midway between Screw and Unscrew.

Or if it is stuck because the drill was really too big, put the drill on the floor and hold it with your foot, grip the drill with channel lock pliers and hit the jaws with a hammer away from the drill.

Drill bit? If it's stuck in a piece of metal try drilling from the other side and then knock it out use a maller drill bit.

Stuck in metal, use vise grips to grab it and turn counter clockwise

Stuck in drill chuck? Get a key for the electric drill. Battery operated, use a par of pair of channel lock pliers to open the chuck.

easy to fix
with the drill not running

grab the bottom part of the spinning part of the drill nearest the drill's motor.
then
grab the spinning shaft bit nearest the drill bit
pull them apart slightly

when the two parts are pushed together thay lock the chuck

I own a ryobi hammer drill that does the same thing

Grab the drill head as hard as you can put the drill on drill setting and the highest number setting and put it reverse

It's just jammed in fully open position, take a set of channel lock pliers around the chuck and unstick it .

OK, try to grab the chuck tightener and loosen by pressing lightly on the drill throttle button in whichever direction it takes to undo the stuck in drill bit.

I do this all the time.

I had the same problem. I put the drill onto Hammer/Chisel action and it helped release the bit.

Do the same in reverse, if possible. Also, you could use two channel locks as most of those chucks have two rings, the narrow one towards the drill itself being attached to the motor. However, make sure the screw inside the chuck is tight first -- I've seen those back out and block chucks open.

Try using the low torque setting on the drill when reversing and something to assist you getting a better grip to hold the chuck from spinning when reversing. This may help.

Good Luck