How do i attach a Wall Mount to the TV?

You need to buy a wall mount.

Wall mount for what size TV?
The answer is probably in the instructions that came with the wall mount.
I need: Size of TV.
What kind of wall you want to attach this TV to.
Remember, I am far away and can't see what you are doing.

look at the middle of the tv the 4 screw mount thats wre the tv wall mount gos. good luck

1- remove the wall plate from the arm.
2- fix the front plate to the back of your television.
3- mark the position of the holes and drill
4- put wall plugs into holes.
5- secure the wall plate to the wall
6-attach the arm to the wall plate.
7-hang the screen on the arm (i recommend having someone help) and secure it in place

sounds like you will need pro help, best to be safe than sorry.

did you figure this out? I only ask because I need the stand for my TV. Could you sell me yours?

Thanks

Anthony
[email protected]

I have my 32" Protron mounted on my wall. There are six holes on the back of the set that you attach the mount. I cant find any links to pictures but it should be pretty straight forward. You should be able to use any generic LCD wall mount, just make sure it can hold an 32" since I made the mistake thinking all wall mounts were the same. I purchased mine at Best Buy but you should be able to find a mount anywhere. You will need to fasten the mount onto the studs in your wall. Drywall by itself will not be sufficient and cannot support the weight of the TV.

The wall mount should come with everything you need, e.g., screws, brackets, etc., with the exception of the tools. FYI... it's not going to be an easy job so be patient and take your time. It's probably going to take the good portion of a day. Also, as for the holes on the back, just be careful when performing the final mount to make sure it doesn't fall. It would be wise to have someone help you.

I have the same TV, and I bought a mount with 4 connector holes. I was able to connect 3 of the 4 and it has been fine as the TV does not weigh too much. The TV was not designed with the current mode of either wall or stand mount. It was just intended for stand. I have had it on the wall for over 2 years.

Attach a wall mount, to back of a 32" sharp, LCD flat panel

The 4 screws that are commnly used are short because they are ususally wide in diameter. Besides if they are too long then they might damage the boards on the TV.